A.less internal corrosion because of lower brine density
B.higher temperature evaporation for lower salinity of the distillate produced
C.less scale formation in a flash evaporator
D.less feed-water required for a flash evaporator
您可能感興趣的試卷
你可能感興趣的試題
A.clarifier
B.oil/water separator
C.incinerator
D.distiller
A.booster pump
B.evaporator
C.incinerator
D.cooler
A.wax precipitation in the lube oil
B.contamination by dust, scale, or moisture
C.refrigerant bubbles in the lube oil
D.refrigerant reducing the lube oil viscosity
A.increasing refrigerant pressure in the coil
B.increasing chilled water flow through the cooler
C.sub-cooling the refrigerant in the condenser
D.superheating the refrigerant in the compressor
A.control inlet air temperature
B.control inlet air volume
C.maintain relative humidity at 15%
D.restore conditioned air temperature to a comfortable level
最新試題
If separating effect is not good, which measure should be taken （）
Refrigerant entering the compressor of a refrigeration system should be in which of the following conditions?（）
（）are used to digest the sewage to produce innocuous sludge in a biological sewage treatment plant.
Thermostatic steam pressure reducing valves are used in the fuel oil service system to control the（）
Using a file without a handle may result in （）
The cetane rating of diesel fuel is an indication of the （）
By comparing the exhaust gas temperature of each cylinder, the operator can determine if the load is balanced throughout the engine. The device most commonly used is a（）
Cold weather starting of a diesel engine may be made easier by（）
The flash point of a residual fuel oil should be used to determine the highest temperature to which oil may be heated（）
The shipboard oil pollution emergency plan will be invalid after （）