A.To add power to the engine
B.To keep the engine firmly attached to its supporting base
C.To keep moving engine part in their proper relative positions
D.To rotate the crankshaft
您可能感興趣的試卷
你可能感興趣的試題
A.droop
B.dead banding
C.dash potting
D.hunting
A.cylinder head cracks
B.piping joints
C.pump leaking
D.all of the above
A.reduce the ring groove wear rate
B.seal against crankcase vapors
C.lessen the wear on aluminum part of the cylinder
D.allow for the greater expansion rate of aluminum
A.a leaking fuel injector nozzle
B.a clogged air filter
C.excessively early fuel injection
D.malfunctioning valves
A.An alarm device with audible and visible signals is required for all cooling water systems
B.Propulsion engines with bores over 200 mm are to be fitted with cooling water jackets
C.Each totally enclosed cooling system shall be provided with a suitable head tank
D.Drain cocks are to be provided at the lowest points of all cylinder water jackets
最新試題
By comparing the exhaust gas temperature of each cylinder, the operator can determine if the load is balanced throughout the engine. The device most commonly used is a（）
Which one is NOT the ‘clear grounds’ for a more detailed inspection?（）
Which of the listed governor characteristics will greatly affect the load sharing relationship between paralleled diesel generators?（）
If separating effect is not good, which measure should be taken （）
To shut down a diesel engine after it exceeds the set maximum speed，which type of device listed should be used?（）
To proceed to the assistance of a ship in distress is（）
A purge recovery system is used in a centrifugal air conditioning or refrigeration system to （）
Which of the diesel engine components listed increase air density and helps to improve engine operating efficiency?（）
The main purpose of port State control is not to（）
The ISPS Code consists of a mandatory section-Part A, which shows（）