A.loss of suction in the circulating pump
B.leak in the primary cooling system
C.broken raw water pump shaft
D.burned or cracked piston in one cylinder
您可能感興趣的試卷
你可能感興趣的試題
A.avoid using liquid-cooled nozzles whenever possible
B.avoid low cooling water temperatures
C.avoid prolonged overloading of the engine
D.make certain the gasket seal between the nozzle and cylinder head is tight
A.centrifugal force rotates the ball-head
B.flyweight centrifugal force is balanced by spring force
C.flyweight centrifugal force is balanced by hydraulic pressure
D.speeder spring alone actuates the fuel control rod
A.too light of a load
B.injection timing is too early
C.overloading of the engine
D.too low of a compression ratio
A.caused by retarded injection timing
B.caused by a mechanical defect in one cylinder
C.caused by high fuel injection pressures
D.normal for these conditions
A.an air bound fuel system
B.damage to cylinder heads and pistons
C.excessive fuel injection
D.excessive air valve lift
最新試題
One of the reasons that cause oil flowed from sludge outlet of a self-cleaning separator is（）
To shut down a diesel engine after it exceeds the set maximum speed，which type of device listed should be used?（）
When does auxiliary burner of incinerator put into operation? （）Ⅰ. start incinerator when it is coldⅡ. the sludge for dealing with is littleⅢ. the sludge for dealing with is largeⅣ. the water and impurity in sludge are too muchⅤ. the temperature in incinerator is lowⅥ. dealing with little solid rubbish
A purge recovery system is used in a centrifugal air conditioning or refrigeration system to （）
（）connectors hold best if a wire is accidentally pulled or a connection becomes loose.
The main purpose of port State control is not to（）
Under MARPOL Code the ship to which it applies has to carry （）
Using a file without a handle may result in （）
If separating effect is not good, which measure should be taken （）
The flash point of a residual fuel oil should be used to determine the highest temperature to which oil may be heated（）