A.Speed limiting governor
B.Over-speed governor
C.Over-speed trip
D.Over-speed relay
您可能感興趣的試卷
你可能感興趣的試題
A.decreased viscosity
B.decreased pour point
C.increased flash point
D.increased viscosity
A.provide a reservoir for cylinder lubrication
B.pump oil into the combustion space for cylinder cooling
C.prevent excessive lubricating oil consumption
D.allow hydraulic oil film formation on the cylinder
A.produce the heat for ignition
B.decrease injection lag
C.increase ignition delay
D.aid in exhausting burnt gases
A.low sulfur content in the fuel
B.a loose injector inlet connection
C.late fuel injection
D.high injection pressure
A.Shape of the piston crowns
B.Increasing the compression ratios
C.Increasing the piston crowns
D.Increasing the turbocharger gear ratio
最新試題
Which one is NOT the ‘clear grounds’ for a more detailed inspection?（）
One of the reasons that cause oil flowed from sludge outlet of a self-cleaning separator is（）
Under MARPOL Code the ship to which it applies has to carry （）
During the diesel engine running, the water level of F.W expansion tank should normally kept in the （） level of glass tube.
If two A.C.generators are to be operated in parallel, the load is distributed evenly by（）
The treatment of the fuel oils involves storage, heating, filtering and（）
（）connectors hold best if a wire is accidentally pulled or a connection becomes loose.
Engine parameters shall be corresponded to NOx Technical Files. This is required by （）
By comparing the exhaust gas temperature of each cylinder, the operator can determine if the load is balanced throughout the engine. The device most commonly used is a（）
The condensers located in various stages of a flash evaporator are cooled by（）