A.higher than the first stage feed-water temperature and absolute shell pressure
B.lower than the first stage feed-water temperature and absolute shell pressure
C.the same as the first stage feed-water temperature and absolute shell pressure
D.not related to the feed-water temperature and absolute shell pressure
您可能感興趣的試卷
你可能感興趣的試題
A.lowering brine discharge density
B.decreasing the absolute pressure of each stage
C.increasing the saltwater feed heater temperature
D.increasing the pressure at the spray pipe
A.Bedplate
B.Block
C.Base
D.Sump
A.clearance between the top of the valve stem and the rocker arm
B.compression of the valve springs
C.clearance between the valve seat inserts and the head
D.out of roundness of the fuel injection cams
A.low lube oil temperature
B.low lube oil pressure
C.high exhaust temperature
D.high cooling water pressure
A.Dirty lube oil filter
B.Too much piston ring wear
C.High lube oil viscosity
D.Low lube oil temperature
最新試題
The flash point of a residual fuel oil should be used to determine the highest temperature to which oil may be heated（）
Refrigerant entering the compressor of a refrigeration system should be in which of the following conditions?（）
Diesel engine air start system check valves are opened by （）
One of the reasons that cause oil flowed from sludge outlet of a self-cleaning separator is（）
Thermostatic steam pressure reducing valves are used in the fuel oil service system to control the（）
During the diesel engine running, the water level of F.W expansion tank should normally kept in the （） level of glass tube.
Which of the following items don’t belong to dock repair works?（）
To shut down a diesel engine after it exceeds the set maximum speed，which type of device listed should be used?（）
Engine parameters shall be corresponded to NOx Technical Files. This is required by （）
As soon as a diesel engine has started, which of the listed engine operating parameters should be checked FIRST?（）