A.over heat
B.over speed
C.over pressure
D.over worn
您可能感興趣的試卷
你可能感興趣的試題
A.increasing the linear velocity of the exhaust gases
B.changing directions of exhaust gas flow
C.decreasing the temperature of the exhaust gases
D.accelerating the exhaust gas through a reduced size orifice
A.change from heavy fuel oil to diesel oil for mail engine
B.pumping oil bilge water
C.change sea chest form high level one to lower one
D.test emergency generator
A.The cetane number has no affect on injection lag
B.The cetane number is an indication of the fuel’s viscosity
C.Ignition lag is reduced with fuels having a high cetane number
D.The cetane number is of little significance in the combustion
A.Ignition lag increases
B.Lube oil system pressure increases
C.Brake specific fuel consumption increased
D.Mechanical efficiency increaded
A.atop the piston crown
B.beneath the piston crown
C.at the base of the piston skirt
D.inside the cylinder liner cooling water jacket
最新試題
As soon as a diesel engine has started, which of the listed engine operating parameters should be checked FIRST?（）
To shut down a diesel engine after it exceeds the set maximum speed，which type of device listed should be used?（）
Refrigerant entering the compressor of a refrigeration system should be in which of the following conditions?（）
The main purpose of port State control is not to（）
Which of the following items don’t belong to dock repair works?（）
During the diesel engine running, the water level of F.W expansion tank should normally kept in the （） level of glass tube.
By comparing the exhaust gas temperature of each cylinder, the operator can determine if the load is balanced throughout the engine. The device most commonly used is a（）
If two A.C.generators are to be operated in parallel, the load is distributed evenly by（）
Engine parameters shall be corresponded to NOx Technical Files. This is required by （）
If separating effect is not good, which measure should be taken （）