A.corrosive deterioration of a bearing
B.inadequate air filtration
C.excessive ring and liner wear
D.excessive cooling of lubricating oil
您可能感興趣的試卷
你可能感興趣的試題
A.lower than normal cylinder pressure and low exhaust temperature
B.lower than normal cylinder pressure and high exhaust temperature
C.higher than normal cylinder pressure and low exhaust temperature
D.higher than normal cylinder pressure and high exhaust temperature
A.engine displacement
B.super-aspirating
C.air injection
D.supercharging
A.increase exhaust back pressure
B.causes excessive crankcase pressure
C.can only be detected by a compression check
D.decreases fuel consumption
A.fuel droplets will burn as they leave the fuel injector
B.fuel will not be properly atomized in the cylinder
C.maximum expansion of the burned fuel cannot take place in the cylinder
D.compression pressure will be too low to cause fuel ignition
A.inside micrometer
B.feeler gauge and straight edge
C.adjustable trammel
D.sighting device
最新試題
The cetane rating of diesel fuel is an indication of the （）
By comparing the exhaust gas temperature of each cylinder, the operator can determine if the load is balanced throughout the engine. The device most commonly used is a（）
If two A.C.generators are to be operated in parallel, the load is distributed evenly by（）
Under MARPOL Code the ship to which it applies has to carry （）
To proceed to the assistance of a ship in distress is（）
Which of the diesel engine components listed increase air density and helps to improve engine operating efficiency?（）
Engine parameters shall be corresponded to NOx Technical Files. This is required by （）
If separating effect is not good, which measure should be taken （）
The treatment of the fuel oils involves storage, heating, filtering and（）
Refrigerant entering the compressor of a refrigeration system should be in which of the following conditions?（）