A.check the pyrometer readings
B.check the crankcase oil level
C.check the fuel oil strainers
D.clean the fuel system
您可能感興趣的試卷
你可能感興趣的試題
A.carbonization of oils from the combustion chambers
B.emulsions of lube oil and water
C.coagulation of unburned fuel below the piston rings
D.all of the above
A.low lube oil temperature
B.low starting air temperature
C.air in the fuel injection
D.water in the starting air system
A.To test the starting system
B.To remove air bubbles from the jacket water
C.To ensure that the lube oil system delivers pressure
D.To ensure foreign material (water etc) is not present in the cylinders
A.gear drive by the engine
B.driven by an exhaust gas turbine
C.driven by a camshaft
D.driven by separate motor
A.fuel line connections to cylinder injection valves
B.gasket surfaces of the fuel oil filters
C.discharge fitting of the fuel injector pumps
D.suction side of the fuel oil tran
最新試題
When does auxiliary burner of incinerator put into operation? （）Ⅰ. start incinerator when it is coldⅡ. the sludge for dealing with is littleⅢ. the sludge for dealing with is largeⅣ. the water and impurity in sludge are too muchⅤ. the temperature in incinerator is lowⅥ. dealing with little solid rubbish
The flash point of a residual fuel oil should be used to determine the highest temperature to which oil may be heated（）
“Insufficiency of manning or insufficiency of certification of seafarers” is an identification of a（）
Refrigerant entering the compressor of a refrigeration system should be in which of the following conditions?（）
During the diesel engine running, the water level of F.W expansion tank should normally kept in the （） level of glass tube.
Under MARPOL Code the ship to which it applies has to carry （）
Which of the diesel engine components listed increase air density and helps to improve engine operating efficiency?（）
（）are used to digest the sewage to produce innocuous sludge in a biological sewage treatment plant.
The ISPS Code consists of a mandatory section-Part A, which shows（）
If two A.C.generators are to be operated in parallel, the load is distributed evenly by（）