A.Compression ratio
B.Fuel/Air ratio
C.Compression pressure
D.Lube oil pressure
您可能感興趣的試卷
你可能感興趣的試題
A.test the starting system
B.remove condensation from the cylinders
C.check the compression
D.check for proper lube oil pressure
A.turn the flywheel
B.reduce friction
C.overcome inertia
D.ignite the fuel
A.lower compression pressures
B.overheating without smoking
C.failure to start
D.a run away without load
A.Flywheel inertia
B.Admission of starting air
C.The way of the vessel
D.securing of fuel to the cylinders
A.decreasing the compression ratio
B.using a special fuel having a high ignition temperature
C.increasing the starting air supply
D.heating the jacket water
最新試題
One of the reasons that cause oil flowed from sludge outlet of a self-cleaning separator is（）
Which of the diesel engine components listed increase air density and helps to improve engine operating efficiency?（）
Which of the following items don’t belong to dock repair works?（）
Which of the listed governor characteristics will greatly affect the load sharing relationship between paralleled diesel generators?（）
When does auxiliary burner of incinerator put into operation? （）Ⅰ. start incinerator when it is coldⅡ. the sludge for dealing with is littleⅢ. the sludge for dealing with is largeⅣ. the water and impurity in sludge are too muchⅤ. the temperature in incinerator is lowⅥ. dealing with little solid rubbish
If separating effect is not good, which measure should be taken （）
The ISPS Code consists of a mandatory section-Part A, which shows（）
The flash point of a residual fuel oil should be used to determine the highest temperature to which oil may be heated（）
The shipboard oil pollution emergency plan will be invalid after （）
Refrigerant entering the compressor of a refrigeration system should be in which of the following conditions?（）