A.an improper rudder response
B.hammering noises in the equipment or transmission lines
C.popping or sputtering noises
D.all the above
您可能感興趣的試卷
你可能感興趣的試題
A.clean the fittings before they are disconnected
B.Place drip pans under leaky fittings
C.Seal any cracks in lines with Permatex
D.Coat all threads with graphite oil
A.molecular fluid vibration
B.energy losses
C.wide pressure variations
D.mechanical damage to control valves
A.provide an area where air can separate from the oil
B.provide an area to separate solid contaminants from the oil
C.act as an oil and water separator
D.absorb shocks occurring in the system
A.act as a shock absorber
B.maintain the stored oil under pressure
C.act as a base or foundation for the power unit
D.eliminate pressure surges in the system
A.admit only enough fresh outside air to provide proper ventilation
B.reduce the air reheating system load
C.lower the compressor head pressure
D.operate the purge recovery unit continuously
最新試題
By comparing the exhaust gas temperature of each cylinder, the operator can determine if the load is balanced throughout the engine. The device most commonly used is a()
Which of the listed governor characteristics will greatly affect the load sharing relationship between paralleled diesel generators?()
Diesel engine air start system check valves are opened by ()
Cold weather starting of a diesel engine may be made easier by()
The shipboard oil pollution emergency plan will be invalid after ()
The main purpose of port State control is not to()
When does auxiliary burner of incinerator put into operation? ()Ⅰ. start incinerator when it is coldⅡ. the sludge for dealing with is littleⅢ. the sludge for dealing with is largeⅣ. the water and impurity in sludge are too muchⅤ. the temperature in incinerator is lowⅥ. dealing with little solid rubbish
If separating effect is not good, which measure should be taken ()
Which of the diesel engine components listed increase air density and helps to improve engine operating efficiency?()
The condensers located in various stages of a flash evaporator are cooled by()