A.Clean all electrical connections
B.Lift the relief valves by hand
C.Inspect and clean all solenoid valves
D.Inspect for oil and water leaks
您可能感興趣的試卷
你可能感興趣的試題
A.carbon deposits on the flame scanner
B.high fuel oil temperature
C.low fuel oil viscosity
D.high steam pressure
A.water in the fuel oil
B.excessive cycling
C.high fuel oil pressure
D.improper burner maintenance
A.cool the furnace to prevent pre-ignition
B.remove explosive vapors from the furnace
C.evaporate accumulated unburned fuel oil
D.provide sufficient air in the furnace to allow ignition of the fuel
A.precipitate silica from solution
B.reduce corrosion in the heating coil
C.prevent clogging and erosion in the coil
D.maintain zero water hardness
A.cyclone furnace boiler type
B.dry back boiler type
C.water-tube type
D.critical circulation boiler type
最新試題
（）connectors hold best if a wire is accidentally pulled or a connection becomes loose.
A purge recovery system is used in a centrifugal air conditioning or refrigeration system to （）
As soon as a diesel engine has started, which of the listed engine operating parameters should be checked FIRST?（）
Which one is NOT the ‘clear grounds’ for a more detailed inspection?（）
When does auxiliary burner of incinerator put into operation? （）Ⅰ. start incinerator when it is coldⅡ. the sludge for dealing with is littleⅢ. the sludge for dealing with is largeⅣ. the water and impurity in sludge are too muchⅤ. the temperature in incinerator is lowⅥ. dealing with little solid rubbish
The shipboard oil pollution emergency plan will be invalid after （）
Refrigerant entering the compressor of a refrigeration system should be in which of the following conditions?（）
By comparing the exhaust gas temperature of each cylinder, the operator can determine if the load is balanced throughout the engine. The device most commonly used is a（）
（） is not installed on the main switchboar.
Flame failure in an automatically fired auxiliary boiler can from a/an （）