A.turning it upside down
B.pressing the foam lever
C.squeezing the grip handle
D.opening the hose valve
您可能感興趣的試卷
你可能感興趣的試題
A.is comfortable
B.is warm
C.is not bleeding
D.has a clear airway
A.wash with salt water
B.wash with sterile mineral oil
C.treat it like frostbite
D.treat it like any burn
A.by more than 5 percent
B.by less than 10 percent
C.to 95 percent
D.to less than 90 percent
A.at any time
B.only after the engine room control station is switched to ‘bridge control’
C.whenever the secondary station is switched to ‘bridge control’
D.whenever the engine side control station is switched to ‘bridge control’
A.one half crankshaft speed in a two-stroke cycle diesel engine
B.crankshaft speed in a two-stroke cycle diesel engine
C.two times crankshaft speed in a two-stroke cycle diesel engine
D.one-fourth times crankshaft speed in a four-stroke cycle diesel engine
最新試題
Diesel engine air start system check valves are opened by ()
()are used to digest the sewage to produce innocuous sludge in a biological sewage treatment plant.
“Insufficiency of manning or insufficiency of certification of seafarers” is an identification of a()
()connectors hold best if a wire is accidentally pulled or a connection becomes loose.
Which of the listed governor characteristics will greatly affect the load sharing relationship between paralleled diesel generators?()
If separating effect is not good, which measure should be taken ()
Refrigerant entering the compressor of a refrigeration system should be in which of the following conditions?()
For a given exhaust gas boiler, what is the quantity of its evaporation mainly determined?()
When does auxiliary burner of incinerator put into operation? ()Ⅰ. start incinerator when it is coldⅡ. the sludge for dealing with is littleⅢ. the sludge for dealing with is largeⅣ. the water and impurity in sludge are too muchⅤ. the temperature in incinerator is lowⅥ. dealing with little solid rubbish
By comparing the exhaust gas temperature of each cylinder, the operator can determine if the load is balanced throughout the engine. The device most commonly used is a()