A.a mechanical seal
B.keyway and key
C.a nut
D.shrinkage
您可能感興趣的試卷
你可能感興趣的試題
A.the thrust pads are while metal faced on both sides
B.the thrust pads are while metal faced only on the forward side
C.the thrust pads are while metal faced only on the after side
D.intermediate shaft usually supported by a plummer block
A.high speeds
B.medium speed
C.low speeds
D.the same speed with the engine
A.check oil level in bearing sump
B.check them for leakagec through end seals
C.pump bilges in time
D.check temperature
A.the after one is more than forward one
B.the forward one is more than after one
C.the forward one is the same with after one
D.it depends on the type of engine
A.the ventilation pipe
B.the water line for fire fighting on the deck
C.the fuel oil line
D.the water supplying line in bath room
最新試題
If separating effect is not good, which measure should be taken （）
Which of the following items don’t belong to dock repair works?（）
Diesel engine air start system check valves are opened by （）
One of the reasons that cause oil flowed from sludge outlet of a self-cleaning separator is（）
The main purpose of port State control is not to（）
To shut down a diesel engine after it exceeds the set maximum speed，which type of device listed should be used?（）
（） is not installed on the main switchboar.
When does auxiliary burner of incinerator put into operation? （）Ⅰ. start incinerator when it is coldⅡ. the sludge for dealing with is littleⅢ. the sludge for dealing with is largeⅣ. the water and impurity in sludge are too muchⅤ. the temperature in incinerator is lowⅥ. dealing with little solid rubbish
To proceed to the assistance of a ship in distress is（）
The ISPS Code consists of a mandatory section-Part A, which shows（）