A.Raising temperature
B.less use of surfactant
C.more use of solvent
D.polishing device fouling prevention
您可能感興趣的試卷
你可能感興趣的試題
A.more economic
B.larger capacity on oil treatment
C.less costive
D.more capable of separating emulsified oil
A.gravity separation
B.centrifuge
C.Cyclone
D.Cross-flow membrane filtration
A.The requirement for the oil content of bilge water discharged is 15 ppm
B.No discharge in sensitive waters
C.Any discharge in sensitive waters
D.International, national or local requirements have to be observed
A.The high temperature facilitates primary gravity separation
B.Most of the oil and organic solvents are raised to the top layer
C.The high the temperature is, the more the top oil will be collected
D.The high temperature has little use on the separation of emulsified oil
A.Oil leaking from tanks inside engine room
B.Engine room cleaning water
C.Water leaking from the separator sludge tank
D.Sewage
最新試題
() is not installed on the main switchboar.
The cetane rating of diesel fuel is an indication of the ()
()connectors hold best if a wire is accidentally pulled or a connection becomes loose.
Refrigerant entering the compressor of a refrigeration system should be in which of the following conditions?()
Which one is NOT the ‘clear grounds’ for a more detailed inspection?()
When does auxiliary burner of incinerator put into operation? ()Ⅰ. start incinerator when it is coldⅡ. the sludge for dealing with is littleⅢ. the sludge for dealing with is largeⅣ. the water and impurity in sludge are too muchⅤ. the temperature in incinerator is lowⅥ. dealing with little solid rubbish
As soon as a diesel engine has started, which of the listed engine operating parameters should be checked FIRST?()
By comparing the exhaust gas temperature of each cylinder, the operator can determine if the load is balanced throughout the engine. The device most commonly used is a()
The ISPS Code consists of a mandatory section-Part A, which shows()
If two A.C.generators are to be operated in parallel, the load is distributed evenly by()