A.foam
B.CO2
C.low velocity water fog
D.high velocity water fog
您可能感興趣的試卷
你可能感興趣的試題
A.close the vent
B.pump out the tank
C.activate the fixed CO2 system
D.cut off the heating coils
A.the lifting appliance can always lift the freight within its rated load
B.attention should be paid in order not to break the wedge when lifting cargo
C.sometimes the lifting work needs other assistance other than the lifting appliance
D.lifting work should be done with every part fit, tightness or adhesion
A.a driver
B.a scraper
C.a tap
D.a file
A.be treated according to the C-Es command exactly
B.be treated according to MARPOL
C.accumulate in bilges or on tank tops in accordance with MARPOL
D.discharge to sea at the specified areas
A.not be put into operation too early
B.be pay adequate attention to
C.be used only when necessary
D.be coated with certain material
最新試題
() is not installed on the main switchboar.
The main purpose of port State control is not to()
To shut down a diesel engine after it exceeds the set maximum speed,which type of device listed should be used?()
The ISPS Code consists of a mandatory section-Part A, which shows()
One of the reasons that cause oil flowed from sludge outlet of a self-cleaning separator is()
Engine parameters shall be corresponded to NOx Technical Files. This is required by ()
By comparing the exhaust gas temperature of each cylinder, the operator can determine if the load is balanced throughout the engine. The device most commonly used is a()
Thermostatic steam pressure reducing valves are used in the fuel oil service system to control the()
As soon as a diesel engine has started, which of the listed engine operating parameters should be checked FIRST?()
Which of the following items don’t belong to dock repair works?()