Refer to the exhibit.The user at Workstation B reports that Server A cannot be reached.What is
preventing Workstation B from reaching Server A？（）
A.The IP address for Server A is a broadcast address.
B.The IP address for Workstation B is a subnet address.
C.The gateway for Workstation B is not on the same subnet.
D.The gateway for Server A is not on the same subnet.
您可能感興趣的試卷
你可能感興趣的試題
A.The switchport belongs only to VLAN 2
B.Interface fa0/0 will be in both VLAN 1 (by default) and VLAN 2
C.The exhibit shows interface fa0/0 to be dynamically mapped to VLAN 2
D.A network host can be connected to this interface
What is the under lying cause of this problem？（）
A. A remote physical layer problem exists.
B. The host NIC is not functioning.
C. TCP/IP has not been correctly installed on the host.
D. A local physical layer problem exists.
A.switch to switch
B.switch to hub
C.switch to router
D.hub to hub
E.router to PC
A.The transport layer divides a data stream into segments and may add reliability and flow control information.
B.The data link layer adds physical source and destination addresses and an FCS to the segment.
C.Packets are created when the network layer encapsulates a frame with source and destination host addresses and protocol-related control information.
D.Packets are created when the network layer adds Layer 3 addresses and control information to a segment.
E.The presentation layer translates bits into voltages for transmission across the physical link.
A.802.1Q native VLAN frames are untagged by default.
B.802.1Q trunking ports can also be secure ports.
C.802.1Q trunks can use 10 Mb/s Ethernet interfaces.
D.802.1Q trunks require full-duplex, point-to-point connectivity.
E.802.1Q trunks should have native VLANs that are the same at both ends.
最新試題
請參見圖示。一臺路由器（其路由表如圖所示）收到發往192.168.1.4的數據包。路由器將如何處理該數據包？（）
何時必須使用clock rate 命令配置路由器串行接口？（）
請參見圖示。電纜1和電纜2分別按照特定的物理層要求接線。哪三個網段使用電纜2？（）
請參見圖示。主機A 和B 無法互相通信。此問題的原因是什么？（）
請參見圖示。RouterB 已經過正確配置。RouterA 的以太網接口Fa0/0已使用如圖所示的命令進行配置。但是，從RouterA 的Fa0/0接口無法成功ping 通RouterB 的Fa0/0接口。應在RouterA 上采取什么措施來解決此問題？（）
請參見圖示。當計算機A 向計算機D 發送幀時，哪些計算機會接收該幀？（）
請參見圖示。哪種邏輯拓?fù)涫菍?duì)圖示網絡的準確描述？（）
請參見圖示。一臺主機正使用NAT 連接到Internet。下列哪三項IP 地址可實現此連接？（）
請參見圖示。已啟用路由器的NAT 功能供PC 訪問Internet?？梢詾槁酚善鹘涌赟0/0/0分配下列哪一個IP 地址？（）
請參見圖示。對于從主機A 向Web 服務器發出的網頁請求，正確的目的套接字?jǐn)?shù)字是什么？（）