A.the session layer
B.the protocol layer
C.the data link layer
D.the access layer
E.the network layer
F.the application layer
您可能感興趣的試卷
你可能感興趣的試題
A.amount of RAM
B.bridge priority
C.IOS version
D.IP address
E.MAC address
F.speed of the links
A.255.255.255.0
B.255.255.255.240
C.255.255.255.248
D.255.255.255.252
E.255.255.255.254
A.RIP
B.BGP
C.OSPF
D.EIGRP
A.hub
B.router
C.switch
D.STP
E.subinterfaces
F.VLAN
A.This is a 10 Mb/s switch port.
B.This is a 100 Mb/s switch port.
C.This is an Ethernet port operating at half duplex.
D.This is an Ethernet port operating at full duplex.
E.This is a port on a network interface card in a PC
最新試題
Which command encrypts all plaintext passwords?()
At which layer of the OSI model is RSTP used to prevent loops?()
Which device might be installed at a branch office to enable and manage an IPsec site-to-site VPN?()
Which statement is true, as relates to classful or classless routing?()
Which pairing reflects a correct protocol-and-metric relationship?()
The network administrator cannot to switch 1 over a telnet session,although the hosts attached to switch 1 can ping the interface Fa0/0 of the router.Given the information in the graphic and assuming that the router and switch2 are configured properly,which of the following commands should be issued on switch 1 to correct this problem?()
Three access ports have been installed and configured to a small office.What term defines the wireless topology?()
Which statement describes the rule of split horizon?()
You have been asked to come up with a subnet mask that will allow all three web servers to be on the same network while providing the max number of subnets.Which network address and subnet mask meet this requirement?()
A network administrator is trying to add a new router into an established OSPF network.The networks attached to the new router do not appear in the routing tables of the other OSPF routers.Given the information in the partial configuration shown below,what configuration error is causing this problem?()Router(config)#router ospf 1Router(config-router)#network 10.0.0.0 255.0.0.0 area 0