A.during high traffic periods
B.after broken links are re-established
C.when upper-layer protocols require high reliability
D.in an improperly implemented redundant topology
E.when a dual ring topology is in use
您可能感興趣的試卷
你可能感興趣的試題
A.TFTP server, Flash, NVRAM
B.ROM, NVRAM, TFTP server
C.NVRAM, TFTP server, ROM
D.Flash, TFTP server, ROM
E.Flash, NVRAM, ROM
A.Filtering can occur based on Layer 3 information.
B.Broadcasts are eliminated.
C.Routers generally cost less than switches.
D.Broadcasts are not forwarded across the router.
E.Adding a router to the network decreases latency.
A.The PC has connectivity with a local host.
B.The PC has connectivity with a Layer 3 device.
C.The PC has a default gateway correctly configured.
D.The PC has connectivity up to Layer 5 of the OSI model.
E.The PC has the TCP/IP protocol stack correctly installed.
A.It creates a global address pool for all outside NAT transactions.
B.It establishes a dynamic address pool for an inside static address.
C.It creates dynamic source translations for all inside local PAT transactions.
D.It creates a one-to-one mapping between an inside local address and an inside global address.
E.It maps one inside source address to a range of outside global addresses.
A.VLAN support
B.compression
C.authentication
D.sliding windows
E.multilink support
F.quality of service
最新試題
Which protocol reduces administrative overhead in a switched network by allowing the configuration of a new VLAN to be distributed to all the switches in a domain?（）
When you are troubleshooting an ACL issue on a router,which command can help you to verify which interfaces are affected by the ACL?（）
What is the result of issuing the frame-relay map ip 192.168.1.2 202 broadcast command?（）
What is the purpose of the cisco Vlan Trunking protocol?（）
After the show ip route command has been entered,the follwing routes are displayed.Which route will not be entered into the routing table of a neighboring router?（）
At which layer of the OSI model dose PPP perform?（）
A network administrator is trying to add a new router into an established OSPF network.The networks attached to the new router do not appear in the routing tables of the other OSPF routers.Given the information in the partial configuration shown below,what configuration error is causing this problem?（）Router(config)#router ospf 1Router(config-router)#network 10.0.0.0 255.0.0.0 area 0
Which Cisco IOS diagnostics command can disrupt the operation of a router under high-load conditions?（）
Which name describes an IPV6 host-enable tunneling technique that uses IPV4 UDP,does not require dedicated gateway tunnels,and can pass through existing IPV4 NAT gateways?（）
On which options are standard access list based?（）