A.can be used over analog circuits
B.maps Layer 2 to Layer 3 address
C.encapsulates several routed protocols
D.supports IP only
E.provides error correction
您可能感興趣的試卷
你可能感興趣的試題
A.default gateway
B.DNS servers
C.FTP server
D.helper address
E.subnet mask
F.TFTP server
A.It sends data in clear text format.
B.It is no longer supported on Cisco network devices.
C.It is more secure than SSH
D.It requires an enterprise license in order to be implemented.
E.It requires that the destination device be configured to support Telnet connections.
A.Switches take less time to process frames than hubs take.
B.Switches do not forward broadcasts.
C.Hubs can filter frames.
D.Using hubs can increase the amount of bandwidth available to hosts.
E.Switches increase the number of collision domains in the network.
A.A successor route is used by EIGRP to forward traffic to a destination.
B.Successor routes are saved in the topology table to be used if the primary route fails.
C.Successor routes are flagged as "active" in the routing table.
D.A successor route may be backed up by a feasible successor route.
E.Successor routes are stored in the neighbor table following the discovery process.
A.Switch1（config-if）# switchport port-security maximum 1
B.Switch1（config）# mac-address-table secure
C.Switch1（config）# access-list 10 permit ip host
D.Switch1（config-if）# switchport port-security violation shutdown
E.Switch1（config-if）# ip access-group 10
最新試題
What is the default administrative distance of OSPF?（）
Which protocol reduces administrative overhead in a switched network by allowing the configuration of a new VLAN to be distributed to all the switches in a domain?（）
Which IPsec security protocol should be used when confidentiality is required?（）
You have been asked to come up with a subnet mask that will allow all three web servers to be on the same network while providing the max number of subnets.Which network address and subnet mask meet this requirement?（）
A network administrator is trying to add a new router into an established OSPF network.The networks attached to the new router do not appear in the routing tables of the other OSPF routers.Given the information in the partial configuration shown below,what configuration error is causing this problem?（）Router(config)#router ospf 1Router(config-router)#network 10.0.0.0 255.0.0.0 area 0
Which command is used to display the collection of OSPF link states?（）
On which options are standard access list based?（）
Which cisco ios command can help to determine the timing of various debug events,relative to each other,when you are debugging a complicated router issue?（）
The network administrator cannot to switch 1 over a telnet session,although the hosts attached to switch 1 can ping the interface Fa0/0 of the router.Given the information in the graphic and assuming that the router and switch2 are configured properly,which of the following commands should be issued on switch 1 to correct this problem?（）
Three access ports have been installed and configured to a small office.What term defines the wireless topology?（）