A.using adapters and access points manufactured by the same company
B.overlapping the wireless cell coverage by at least 10%
C.configuring all access points to use the same channel
D.utilizing MAC address filtering to allow the client MAC address to authenticate with the surrounding APs
您可能感興趣的試卷
你可能感興趣的試題
A.AES-CCMP
B.PPK via IV
C.PSK
D.TKIP/MIC
A.transparent
B.auto
C.on
D.desirable
E.blocking
F.forwarding
A.Full-duplex Ethernet consists of a shared cable segment. Half-duplex Ethernet provides a point-to-point link.
B.Full-duplex Ethernet uses a loopback circuit to detect collisions. Half-duplex Ethernet uses a jam signal.
C.Full-duplex Ethernet can provide higher throughput than can half-duplex Ethernet of the same bandwidth.
D.Full-duplex Ethernet uses two wires to send and receive. Half-duplex Ethernet uses one wire to send and receive.
A.copier
B.microwave oven
C.toaster
D.cordless phone
E.IP phone
F.AM radio
A.VTP
B.STP
C.ISL
D.802.1Q
E.VLSM
最新試題
Which statement is true, as relates to classful or classless routing?（）
Three switches are connected to one anther via trunk ports.Assuming the default switch configuration,which switch is elected as the root bridge for the spanning-tree instance of vlan 1?（）
Which Cisco IOS diagnostics command can disrupt the operation of a router under high-load conditions?（）
A network administrator is trying to add a new router into an established OSPF network.The networks attached to the new router do not appear in the routing tables of the other OSPF routers.Given the information in the partial configuration shown below,what configuration error is causing this problem?（）Router(config)#router ospf 1Router(config-router)#network 10.0.0.0 255.0.0.0 area 0
Which name describes an IPV6 host-enable tunneling technique that uses IPV4 UDP,does not require dedicated gateway tunnels,and can pass through existing IPV4 NAT gateways?（）
What is the default administrative distance of OSPF?（）
Which command encrypts all plaintext passwords?（）
The network administrator cannot to switch 1 over a telnet session,although the hosts attached to switch 1 can ping the interface Fa0/0 of the router.Given the information in the graphic and assuming that the router and switch2 are configured properly,which of the following commands should be issued on switch 1 to correct this problem?（）
After the show ip route command has been entered,the follwing routes are displayed.Which route will not be entered into the routing table of a neighboring router?（）
Which device might be installed at a branch office to enable and manage an IPsec site-to-site VPN?（）