單項(xiàng)選擇題In order to configure two routers as anycast RPs，which of these requirements，at a minimum， must be satisfied？（）

A.Multicast Source Discovery Protocol mesh-groups must be configured between the two anycast RPs.
B.The RPs must be within the same IGP domain.
C.Multicast Source Discovery Protocol must be configured between the two anycast RPs.
D.The two anycast RPs must be IBGP peers.


您可能感興趣的試卷

你可能感興趣的試題

2.單項(xiàng)選擇題The ip pim autorp listener command is used to do which of these？（）

A.enable a Cisco router to "passively" listen to Auto-RP packets without the router actively sending or forwarding any of the packets
B.allow Auto-RP packets in groups 224.0.1.39 and 224.0.1.40 to be flooded in dense mode out interfaces configured with the ip pim sparse-mode command
C.enable the use of Auto-RP on a router
D.configure the router as an Auto-RP mapping agent

4.單項(xiàng)選擇題Which of these statements about PIM join messages in classic PIM-SM is correct？（）

A.PIM join messages are sent every 60 seconds to refresh the upstream router’s mroute state for the multicast tree.
B.Routers send a PIM join acknowledgement in response to each PIM join message received from a downstream router.
C.PIM join messages are only sent when the multicast distribution tree is first being established.
D.PIM join messages are sent every three minutes to refresh the upstream router’s mroute state for the multicast tree.

5.單項(xiàng)選擇題In PIM-SM what control plane signaling must a multicast source perform before it begins to send multicast traffic to a group？（）

A.The source must send a PIM Register message to the rendezvous point （RP）
B.The source must first join the multicast group using IGMP before sending
C.The source must perform a Request to Send （RTS） and Clear to Send （CTS） handshake with the PIM designated router （DR）
D.No control plane signaling needs to be performed；the source can simply begin sending on the local subnet