what does three entries of the diagram mean? 給一張show ip bgp如下
您可能感興趣的試卷
你可能感興趣的試題
A.examine all packets received to make sure that the source addresses and source interfaces appear in the routing table and match the interfaces where the packets were received
B.check to see if any packet received at a router interface arrives on the best return path
C.combine with a configured ACL
D.log its events,if you specify the logging options for the ACL entries used by the unicast rpf command
E.inspect IP packets encapsulated in tunnels, such as GRE
A.It is applied only on the input interface of a router.
B.It is applied only on the output interface of a router.
C.It can be configured either on the input or output interface of a router.
D.It cannot be configured on a router interface.
E.It is configured under any routing protocol process.
A.Configure a routing process using the command ipv6 router ospf [process-id].
B.Add the network statement for the interfaces on which OSPF will run.
C.Configure OSPF on the interface that it will run on.
D.Use the passive-interface command on the interfaces on which OSPF should not run.
E.Enable routing.
A.BGP peers must be Layer 2-adjacent.
B.EBGP multihop is not configured.
C.The firewall is not configured to allow IP protocol 89.
D.The firewall is not configured to allow UDP 179.
最新試題
As a CCNA candidate,you must have a firm understanding of the IPv6 address structure.Refer to IPv6 address,could you tell me how many bits are included in each filed?()
A default Frame Relay WAN is classified as what type of physical network?()
SPT初始狀態(tài)之后的一個狀態(tài)是什么?
What is method list for configure aaa?
R1 will choose which path to reach 10.1.0.0?
Which of the following describes the roles of devices in a WAN?()
Refer to the exhibit.Which statement describes DLCI 17?()
Refer to the exhibit.What is the meaning of the term dynamic as displayed in the output of the show frame-relay map command shown?()
A network administrator is troubleshooting the OSPF configuration of routers R1 and R2.The routers cannot establish an adjacency relationship on their common Ethernet link.The graphic shows the output of the show ip ospf interface e0 command for routers R1 and R2.Based on the information in the graphic,what is the cause of this problem?()
什么是NAT?