A.Each interface has a different OSPF cost.
B.Each interface is configured with secondary addresses as well as primary addresses.
C.Each interface has a different MTU size.
D.Each interface is configured with theip unnumbered loopback 0 command.
您可能感興趣的試卷
你可能感興趣的試題
Refer to the exhibit. Router E learned about the PIM RP （designated as 7.7.7.7） from four different sources. Routers A and D advertised the 7.0.0.0 network via EIGRP. Routers B and C advertised the 7.0.0.0 network via OSPF. Considering that all four Ethernet interfaces on router E could potentially lead back to the PIM-RP， when router E receives the first multicast packet down the shared tree， which incoming interface will be used to successfully pass the RPF check？（）
A.E0
B.E1
C.E2
D.E3
E.None of these interfaces will be used to successfully pass the RPF check
F.All of these interfaces would successfully pass the RPF check
On the basis of the network provided in the exhibit， all routers are configured to run EIGRP on all links. If the link between PG-R1 and PG-R2 fails， what is the maximum number of queries PG-R3 will receive for 192.168.1.0/24， assuming that all the packets sent during convergence are transmitted once （there are no dropped or retransmitted packets）？（）
A.PG-R3 will receive up to four queries for 192.168.1.0/24， one each from PG-R2， PG-R4， PGR5，and PG-R6.
B.PG-R3 will receive up eight queries for 192.168.1.0/24， one from PG-R2， two from PG-R4，three from PG-R5， and four from PG-R6.
C.PG-R3 will receive one query for 192.168.1.0/24， since the remote routers， PG-R4， PG-R5， and PG-R6， are natural stubs in EIGRP
D.PG-R3 will not receive any queries from PG-R2， because there are no alternate paths for 192.168.1.0/24.
最新試題
what is the advantage of policing opposite to shaping？
What is the three main step of using the QoS feature with MQC command line interface？
什么是NAT？
A default Frame Relay WAN is classified as what type of physical network?（）
Which of the following are key characteristics of PPP?（）
what is four ospf area type？
When upgrading the IOS image,the network administrator receives the exhibited error message.What could be the cause of this error?（）
Refer to the exhibit.What is the meaning of the term dynamic as displayed in the output of the show frame-relay map command shown？（）
The Frame Relay network in the diagram is not functioning properly.What is the cause of the problem?（）
A network administrator is troubleshooting the OSPF configuration of routers R1 and R2.The routers cannot establish an adjacency relationship on their common Ethernet link.The graphic shows the output of the show ip ospf interface e0 command for routers R1 and R2.Based on the information in the graphic,what is the cause of this problem?（）