問答題

三臺路由器,問:在路由器B(即中間的那臺路由器)上的E0/1的IN方向做一個ACL,要求路由器A可以TELNET路由器C,但是路由器C不可以TELNET路由器A。要求寫出ACL命令行。


您可能感興趣的試卷

你可能感興趣的試題

2.單項選擇題Which mechanism can you use to achieve sub-second failover for link failure detection when a switched Ethernet media is used and loss of signal is not supported by the link provider?()

A.OSPF standard hellos
B.Cisco Discovery Protocol link detection
C.Bidirectional Forwarding Detection
D.Fast Link Pulse
E.autonegotiation

3.單項選擇題

Refer to the exhibit. R2 and R3 are routers connected using Ethernet services from a service provider and can receive pings from each other. OSPF is configured as the routing protocol but adjacency is not happening. According to the output of the show commands in the exhibit, what could be the most likely cause of the problem?()

A.Ethernet interfaces were configured as point-to-point.
B.Process IDs are not matching.
C.Configured bandwidths do not match on both interfaces.
D.Broadcasts and multicast are not being propagated over the Ethernet services.
E.OSPF cost does not match on both interfaces.

最新試題

問一個怎么樣的屬性,能讓路由不通告給任何的peer?

題型:?jiǎn)柎痤}

一堆交換機一個server、一個transpare,問配置prune在哪里配置?

題型:?jiǎn)柎痤}

A network administrator is troubleshooting the OSPF configuration of routers R1 and R2.The routers cannot establish an adjacency relationship on their common Ethernet link.The graphic shows the output of the show ip ospf interface e0 command for routers R1 and R2.Based on the information in the graphic,what is the cause of this problem?()

題型:?jiǎn)雾?xiàng)選擇題

R1 will choose which path to reach 10.1.0.0?

題型:?jiǎn)柎痤}

如何實現擁塞避免?

題型:?jiǎn)柎痤}

aaa架構中哪個是要求用戶輸入用戶名和密碼?

題型:?jiǎn)柎痤}

QoS Mechanisms:?jiǎn)栐诓渴餛oS中要用的3個mechanisms是什么?

題型:?jiǎn)柎痤}

What is method list for configure aaa?

題型:?jiǎn)柎痤}

Refer to the exhibit.The network administrator is in acampus building distant from Building B.WANRouter is hosting a newly installed WAN link on interface S0/0.The new link is not functioning and the administrator needs to determine if the correct cable has been attached to the S0/0 interface.How can the administrator accurately verify the correct cable type on S0/0 in the most efficient manner?()

題型:?jiǎn)雾?xiàng)選擇題

什么是NAT?

題型:?jiǎn)柎痤}