A.Router# show ip eigrp adjacency
B.Router# show ip eigrp topology
C.Router# show ip eigrp interfaces
D.Router# show ip eigrp neighbors
您可能感興趣的試卷
你可能感興趣的試題
A.The command is accepted and the respective VLAN is added to vlan dat.
B.The command is rejected.
C.The command is accepted and you must configure the VLAN manually.
D.The port turns amber.
A.after broken links are re-established
B.in an improperly implemented redundant topology
C.when upper-layer protocols require high reliability
D.during high traffic periods
E.when a dual ring topology is in use
A.ping
B.tracert
C.ipconfig
D.show ip route
E.winipcfg
F.show interfaces
Refer to the exibit .An attempt to deny web access to a subnet blocks all traffic from the subnet.Which interface command immedicately removes the effect of ACL 102?()
A.no ip access-group 102 in
B.no ip access-group 102 out
C.no ip access-list 102 in
D.no ip access-class 102 out
E.no ip access-class 102 in
A.Addresses in a private range will be not routed on the Internet backbone.
B.Only the ISP router will have the capability to access the public network.
C.The NAT process will be used to translate this address in a valid IP address.
D.Several automated methods will be necessary on the private network.
E.A conflict of IP addresses happens, because other public routers can use the same range.
最新試題
What are the Popular destinations for syslog messages to be saved? ()
Refer to the exhibit.If the router Cisco returns the given output and has not had its router ID set manually, what value will OSPF use as its router ID?()
Which statement describes VRRP object tracking?()
Which three features are added in SNMPv3 over SNMPv2? ()
What Netflow component can be applied to an interface to track IPv4 traffic?()
Which statement describes the process ID that is used to run OSPF on a router ?()
What is the default Syslog facility level?()
What command instructs the device to timestamp Syslog debug messages in milliseconds?()
What are two benefits of using a single OSPF area network design?()
What command visualizes the general NetFlow data on the command line?()