多項選擇題What are two reasons a network administrator would use CDP?()

A. to verify the type of cable interconnecting two devices
B. to determine the status of network services on a remote device
C. to obtain VLAN information from directly connected switches
D. to verify Layer 2 connectivity between two devices when Layer 3 fails
E. to obtain the IP address of a connected device in order to telnet to the device
F. to determine the status of the routing protocols between directly connected routers


您可能感興趣的試卷

你可能感興趣的試題

1.多項選擇題Which two locations can be configured as a source for the IOS image in the boot system command?()

A.RAM
B.NVRAM
C.flash memory
D.HTTP server
E.TFTP server
F.Telnet server

2.多項選擇題A network administrator is explaining VTP configuration to a new technician. What should the network administrator tell the new technician about VTP configuration?()

A. A switch in the VTP client mode cannot update its local VLAN database.
B. A trunk link must be configured between the switches to forward VTP updates.
C. A switch in the VTP server mode can update a switch in the VTP transparent mode.
D. A switch in the VTP transparent mode will forward updates that it receives to other switches.
E. A switch in the VTP server mode only updates switches in the VTP client mode that have a higher VTP revision number.
F. A switch in the VTP server mode will update switches in the VTP client mode regardless of the configured VTP domain membership.

3.多項選擇題Before installing a new, upgraded version of the IOS, what should be checked on the router, and which command should be used to gather this information?()

A. the amount of available ROM
B. the amount of available flash and RAM memory
C. the version of the bootstrap software present on the router
D. show version
E. show processes
F. show running-config

4.多項選擇題What can be done to secure the virtual terminal interfaces on a router?()

A. Administratively shut down the interface.
B. Physically secure the interface.
C. Create an access list and apply it to the virtual terminal interfaces with the access-group command.
D. Configure a virtual terminal password and login process.
E. Enter an access list and apply it to the virtual terminal interfaces using the access-class command.

5.多項選擇題Which of the following IP addresses can be assigned to the host devices?()

A.205.7.8.32/27
B.191.168.10.2/23
C.127.0.0.1
D.224.0.0.10
E.203.123.45.47/28
F.10.10.0.0/13

最新試題

Which protocol reduces administrative overhead in a switched network by allowing the configuration of a new VLAN to be distributed to all the switches in a domain?()

題型:?jiǎn)雾?xiàng)選擇題

What is the subnetwork address for a host with the IP address 201.100.5.68/28?()

題型:?jiǎn)雾?xiàng)選擇題

Which statement describes the rule of split horizon?()

題型:?jiǎn)雾?xiàng)選擇題

Which command displays the CHAP authentication process as it occurs between two routers?()

題型:?jiǎn)雾?xiàng)選擇題

After the show ip route command has been entered,the follwing routes are displayed.Which route will not be entered into the routing table of a neighboring router?()

題型:?jiǎn)雾?xiàng)選擇題

What is the default administrative distance of OSPF?()

題型:?jiǎn)雾?xiàng)選擇題

The network administrator cannot to switch 1 over a telnet session,although the hosts attached to switch 1 can ping the interface Fa0/0 of the router.Given the information in the graphic and assuming that the router and switch2 are configured properly,which of the following commands should be issued on switch 1 to correct this problem?()

題型:?jiǎn)雾?xiàng)選擇題

At which layer of the OSI model is RSTP used to prevent loops?()

題型:?jiǎn)雾?xiàng)選擇題

Which pairing reflects a correct protocol-and-metric relationship?()

題型:?jiǎn)雾?xiàng)選擇題

Which name describes an IPV6 host-enable tunneling technique that uses IPV4 UDP,does not require dedicated gateway tunnels,and can pass through existing IPV4 NAT gateways?()

題型:?jiǎn)雾?xiàng)選擇題