A.EIGRP will not be accepted when configured on the actual RIPv2 routers.
B.OSPF will no longer be used in the routing table， because you only have EIGRP internal routes running.
C.OSPF will no longer be used in the routing table， because you only have EIGRP external routes running.
D.RIPv2 will populate its RIP database but not its routing table， because you only have EIGRP external routes running.
E.RIPv2 will populate its RIP database but not its routing table， because you only have EIGRP internal routes running.
F.OSPF database will have RIPv2 routes.
您可能感興趣的試卷
你可能感興趣的試題
A.The trunking configuration mode on Switch1 is set to Off.
B.The trunking configuration mode on the other end is set to On.
C.The trunking configuration mode on the other end is set to Desirable.
D.Cisco Discovery Protocol is not running on the other end.
E.There is a VTP domain name mismatch.
F.Switch1 does not support 802.1Q
A.BGP peers must be Layer 2-adjacent.
B.EBGP multihop is not configured.
C.The firewall is not configured to allow IP protocol 89.
D.The firewall is not configured to allow UDP 179.
A.route redistribution
B.import and export using route descriptors
C.import and export using route targets
D.Cisco MPLS Traffic Engineering
A.CEF
B.FIB
C.LFIB
D.IGP
A.interface bandwidth
B.interface delay
C.interface bandwidth and delay
D.hop count
E.bridge priority
最新試題
Which statement is correct about an OSPF sham-link？（）
What does the OSPF command capability vrf-lite achieve？（）
For the following protocols， which one provides a mechanism to transparently intercept and redirect CIFS traffic from a client to a local Cisco Wida Area Application engine？（）
Which statement best describes OSPF external LSAs （type 5）？（）
Which three statements are true about policing？ （）
f a Cisco switch is configured with VTPv1 in transparent mode， what is done with received VTP advertisements？（）
IEEE 802.1w is a Rapid Spanning Tree Protocol （RSTP） that can be seen as an evolution of the 802.1 standard. What are the port roles described by 802.1w？（）
You are the network administrator of a Layer 3 switched network. Users in one VLAN are complaining that access to the server VLAN is very slow from time to time. Traffic in the local VLAN works without any issue， and users in other VLANs do not have any complaint to reach the server VLAN. What is most likely the cause of this issue？（）
What is the command to configure RSVP to reserve up to one-tenth of a Gigabit link， but only allow each individual flow to use 1 MB/s？（）
An administrator of a peer-to-peer server application reports that the maximum bandwidth that his application receives is 90 Mb/s. You have an 8-port，100-Mb/s EtherChannel bundle on the switching infrastructure between the two servers， resulting in a bidirectional throughput of more than what is recorded. Which two solutions would allow for more bandwidth for the application？（）