A. show command
B. debug command
C. configuration command
D. rommon command
您可能感興趣的試卷
你可能感興趣的試題
A. 8 subnets, 31 hosts
B. 8 subnets, 32 hosts
C. 16 subnets, 30 hosts
D. 16 subnets, 32 hosts
E. A Class B address can't be subnetted into the fourth octet.
Users have been complaining that their Frame Relay connection to the corporate site is very slow. The network administrator suspects that the link is overloaded. Based on the partial output of the Router# show frame relay pvc command shown in the graphic, which output value indicates to the local router that traffic sent to the corporate site is experiencing congestion?（）
A. DLCI = 100
B. last time PVC status changed 00:25:40
C. in BECN packets 192
D. in FECN packets 147
E. in DE packets 0
A. 131.1.123.30
B. 131.1.123.31
C. 131.1.123.32
D. 131.1.123.33
A. show chap authentication
B. show interface serial0
C. debug ppp authentication
D. debug chap authentication
E. show ppp authentication chap
A. Router# show ip eigrp adjacency
B. Router# show ip eigrp topology
C. Router# show ip eigrp interfaces
D. Router# show ip eigrp neighbors
最新試題
How are VTP advertisements delivered to switches across the network?（）
Which command is used to display the collection of OSPF link states?（）
Which statement describes the rule of split horizon?（）
Which encapsulation type is a Frame Relay encapsulation type that is supported by Cisco routers?（）
What is the purpose of the cisco Vlan Trunking protocol?（）
Which Cisco IOS diagnostics command can disrupt the operation of a router under high-load conditions?（）
Which device might be installed at a branch office to enable and manage an IPsec site-to-site VPN?（）
At which layer of the OSI model is RSTP used to prevent loops?（）
After the show ip route command has been entered,the follwing routes are displayed.Which route will not be entered into the routing table of a neighboring router?（）
The network administrator cannot to switch 1 over a telnet session,although the hosts attached to switch 1 can ping the interface Fa0/0 of the router.Given the information in the graphic and assuming that the router and switch2 are configured properly,which of the following commands should be issued on switch 1 to correct this problem?（）