單項選擇題There are no boot system commands in a router configuration in NVRAM.What is the fallback sequence that router will use to find an ios during reload?()

A. Flash,TFTP server,ROM
B. Flash,NVRAM,ROM
C. ROM,NVRAM,TFTP server
D. NVRAM,TFTP server,ROM
E. TFTP server,Flash,NVRAM


您可能感興趣的試卷

你可能感興趣的試題

1.單項選擇題Which command shows your active Telnet connections?()

A. show session
B. show cdp neighbors
C. show users
D. show queue

2.單項選擇題Which commands is necessary to permit SSH or Telnet access to a cisco switch that is otherwise configured for these vty line protocols?()

A. transport type all
B. transport output all
C. transport preferred all
D. transport input all

4.單項選擇題Which dose the frame-relay interface-dlci command configure?()

A. remote DLCI on the main interface
B. local DLCI on the main interface
C. local DLCI on the subinterface
D. remote DLCI on the subinterface

5.單項選擇題Which command can be a router to verify the layer 3 path to a host?()

A. traceroute address
B. tracert address
C. ssh address
D. telnet address

最新試題

Which cisco ios command can help to determine the timing of various debug events,relative to each other,when you are debugging a complicated router issue?()

題型:單項選擇題

The network administrator cannot to switch 1 over a telnet session,although the hosts attached to switch 1 can ping the interface Fa0/0 of the router.Given the information in the graphic and assuming that the router and switch2 are configured properly,which of the following commands should be issued on switch 1 to correct this problem?()

題型:單項選擇題

A network administrator is trying to add a new router into an established OSPF network.The networks attached to the new router do not appear in the routing tables of the other OSPF routers.Given the information in the partial configuration shown below,what configuration error is causing this problem?()Router(config)#router ospf 1Router(config-router)#network 10.0.0.0 255.0.0.0 area 0

題型:單項選擇題

Which Cisco IOS diagnostics command can disrupt the operation of a router under high-load conditions?()

題型:單項選擇題

Which encapsulation type is a Frame Relay encapsulation type that is supported by Cisco routers?()

題型:單項選擇題

Which device might be installed at a branch office to enable and manage an IPsec site-to-site VPN?()

題型:單項選擇題

An employee of ABC company has move to an office on a different floor. Although the administrator is able to telnet to all of the routers,the address of Switch F is needed in order to verify that the employee remains in the same VLAN.Which action could be used by the administrator to find the IP address of Switch F?()

題型:單項選擇題

If all OSPF routers in a single area are configured with the same priority value,what value dose a router use for the ODPF router ID in the absence of a loopback interface?()

題型:單項選擇題

Which address is the IPV6 all-RIP-routers muticast group address that is used by RIPng as the destaion address?()

題型:單項選擇題

Which statement describes the rule of split horizon?()

題型:單項選擇題