A. redundant
B. spanned
C. provisioned
D. converged
您可能感興趣的試卷
你可能感興趣的試題
A. NCP
B. LCP
C. ISDN
D. DLCI
E. SLIP
A. 10.188.31.0/27
B. 10.188.31.0/26
C. 10.188.31.0/29
D. 10.188.31.0/28
E. 10.188.31.0/25
A. Configure the switch to be in VTP client mode.
B. Configure the switch to be in VTP domaint mode.
C. Configure the switch to be in VTP transparent mode.
D. Configure the switch to be in VTPv2.
A. proxy.
B. dual-stack
C. tunneling
D. dot1q
A. user EXEC mode
B. global configuration mode
C. privileged EXEC mode
D. auxiliary setup mode
最新試題
Which statement describes the rule of split horizon?（）
Which address is the IPV6 all-RIP-routers muticast group address that is used by RIPng as the destaion address?（）
An administrator must assign static IP addresses to the servers in a network.For network 192.168.20.24/29, the router is assigned the first usable host address while the sales server is given the last usable host address. Which of the following should be entered into the IP propertied box for the sales server?（）
Which command encrypts all plaintext passwords?（）
What is the purpose of the cisco Vlan Trunking protocol?（）
A router receives information about network 192.168.10.0/24 from multiple sources.What will the router consider the most reliable information about the path to that network?（）
What is the result of issuing the frame-relay map ip 192.168.1.2 202 broadcast command?（）
A network administrator is trying to add a new router into an established OSPF network.The networks attached to the new router do not appear in the routing tables of the other OSPF routers.Given the information in the partial configuration shown below,what configuration error is causing this problem?（）Router(config)#router ospf 1Router(config-router)#network 10.0.0.0 255.0.0.0 area 0
Which command is used to display the collection of OSPF link states?（）
The network administrator cannot to switch 1 over a telnet session,although the hosts attached to switch 1 can ping the interface Fa0/0 of the router.Given the information in the graphic and assuming that the router and switch2 are configured properly,which of the following commands should be issued on switch 1 to correct this problem?（）