Refer to the exhibit. VLAN2， VLAN3， and VLAN10 are configured on the switch D-SW1.Host computers are on VLAN 2 （10.1.2.0）， servers are on VLAN 3 （10.1.3.0）， and the
management VLAN is on VLAN10 （10.1.10.0）. Hosts are able to ping each other but are unable toreach the servers. On the basis of the exhibited output， which configuration solution could rectifythe problem？（）
A.Enable IP routing on the switch D-SW1
B.Configure a default route that points toward network 200.1.1.0/24
C.Assign an IP address of 10.1.3.1/24 to VLAN3
D.Configure default gateways to IP address 10.1.2.1 on each host
E.Configure default gateways to IP address 10.1.10.1 on each host
F.Configure default gateways to IP address 200.1.1.2 on each host
您可能感興趣的試卷
你可能感興趣的試題
Refer to the exhibit. Host A and Host B are connected to the Catalyst 3550 switch and have beenassigned to their respective VLANs. The rest of the 3550 configuration is the default configuration.Host A is able to ping its default gateway， 10.10.10.1， but is unable to ping Host B. Given theoutput displayed in the exhibit， which statement is true？（）
A.HSRP must be configured on SW1
B.A separate router is required to support interVLAN routing
C.Interface VLAN 10 must be configured on the SW1 switch
D.The global config command ip routing must be configured on the SW1 switch
E.VLANs 10 and 15 must be created in the VLAN database mode
F.VTP must be configured to support interVLAN routing
A.The access layer is the initial point at which traffic enters the network. Traffic is marked （orremarked） at Layers 2 and 3 by the access switch as it enters the network， or is "trusted" that it isentering the network with the appropriate tag
B.No traffic marking occurs at the core layer. Layer 2/3 QoS tags are trusted from distributionlayer switches and used to prioritize and queue the traffic as it traverses the core
C.Traffic inbound from the access layer to the distribution layer can be trusted or reset dependingupon the ability of the access layer switches. Priority access into the core is provided based onLayer 3 QoS tags
D.IP precedence， DSCP， QoS group， IP address， and ingress interface are Layer 2 characteristics that are set by the access layer as it passes traffic to the distribution layer. Thedistribution layer， once it has made a switching decision to the core layer， strips these off
E.MAC address， Multiprotocol Label Switching （MPLS）； the ATM cell loss priority （CLP） bit， theFrame Relay discard eligible （DE） bit， and ingress interface are established by the voicesubmodule （distribution layer） as traffic passes to the core layer
F.The distribution layer inspects a frame to see if it has exceeded a predefined rate of trafficwithin a certain time frame， which is typically a fixed number internal to the switch. If a frame isdetermined to be in excess of the predefined rate limit， the CoS value can be marked up in a waythat results in the packet being dropped
A.QoS classified at layer 3 using IP precedence or DSCP
B.Guaranteed rate service
C.Implemented using FIFO queues
D.All traffic has an equal chance of being dropped
A.Quality of Service （QoS）
B.Intelligent platforms
C.Mobility and scalability
D.Security
E.High availability
A.The use of a queuing method that will give VoIP traffic strict priority over other traffic
B.The use of RTP header compression for the VoIP traffic
C.The proper classification and marking of the traffic as close to the source as possible
D.The use of 802.1QinQ trunking for VoIP traffic
E.The use of WRED
最新試題
Which statement correctly describes IPsec VPN backup technology？（）
Study the exhibit carefully.Routers A and B are customer routers. Routers 1， 2， 3 and 4 are provider routers. The routers areoperating with various IOS versions. Which frame mode MPLS configuration statement is true？（）
Which three statements accurately describe IOS Firewall configurations？（）
Drag each element of the Cisco IOS Firewall Feature Set from the above and drop onto itsdescription on the below.
Drag the protocols that are used to distribute MPLS labels from the above to the target area on thebelow.（Not all options will be used）
Drag and drop each function on the above to the hybrid fiber-coaxial architecture component that itdescribes on the below.
cisco ios command to interface dialer 0
Drag and drop question. The upper gives the MPLS functions， the bottom describes the planes.Drag the above items to the proper location at the below
Which two encapsulation methods require that an 827 ADSL router be configured with a PPPusername and CHAP password？（）
Which statement about PPPoA configuration is correct？（）