A.May have Ethernet as well as non-Ethernet interfaces
B.Traditionally used as a standalone device for inter-VLAN communication
C.Makes use of TCAMs
D.Uses subinterfaces to define trunks
E.Can use both Layer 2 and Layer 3 to make forwarding decisions
F.Allows the definition of Switched Virtual Interfaces（SVI）
您可能感興趣的試卷
你可能感興趣的試題
A.Use the ip nbar pdlm command to allow NBAR to reference a new PDLM in flash memory
B.If NBAR doesn’t recognize certain applications you must contact Cisco and ask them to emailyou a new PDLM for that application
C.Use the ip nbar port-map command to allow NBAR to recognize certain applications with anev/port number
D.The applications not being recognized can be rerouted to an NBAR collector， which has a morecomplete list of applications
E.Use the copy nbar flash： command to download a new PDLM file to flash
F.Use the ip nbar pdlm command to download a new NBAR reference file from the Cisco website
A.Routing loops
B.Misconfiguration of VPN end points
C.Overiapping IP address space
D.DMVPN
E.User profiles
F.MTU
Which of the following is a valid representation of the following IPv6 address：
2001：0000：0000：0abc：0000：0000：000a：000b？ Choose the answer with the least number of digits.（）
A.2001：0000：0：abc：0000：0000：a：b
B.2001：：abc：：a：b
C.2001：：abc：0：0：000a：000b
D.2001：：0abc：0000：0000：a：b
E.2001：0000：0000：abc：：a：b
F.2001：：abc：0：0：a：b
A.Quality of Service
B.Trunk configuration
C.Access lists
D.Routing protocol configuration
E.Power over Ethernet
F.DHCP configuration
A.Create an IPv4 tunnel and assign the tunnel IPv6 addresses
B.Create IPv4 interfaces on both ends of the network， and use either static routes or a routingprocess to direct IPv6 packets through those interfaces
C.IPv6 packets cannot be encapsulated with IPv4 headers because the addresses are notcompatible
D.Create IFV6 interfaces on both ends of the network， and use static routes to point the IPv4address to those interfaces
E.Use an IPv6 routing protocol like OSPFv3 and assign IPv4 packets to that process
F.Create an IPv4 tunnel and use the tunnel mode ipv6ip command
最新試題
As a network engineer， do you know for what purpose SDM uses Security Device Event Exchange（SDEE）？（）
Drag and drop each function on the above to the hybrid fiber-coaxial architecture component that itdescribes on the below.
Study this exhibit carefully. What information can be derived from the SDM firewall configurationdisplayed？（）
Which statement about PPPoA configuration is correct？（）
A new router was configured with the following commands：The configuration above was found on an Internet Service Provider’s （ISP） Multiprotocol LabelSwitching （MPLS） network. What is its purpose？（）
Drag the DSL local loop topic on the left to the correct descriptions on the right.
Identify the recommended steps for worm attack mitigation by dragging and dropping them into thetarget area in the correct order.
Drag the DSL technologies on the left to their maximum（down/up） data rate values on the below.
cisco ios command to interface dialer 0
Drag the protocols that are used to distribute MPLS labels from the above to the target area on thebelow.（Not all options will be used）