多項選擇題

Refer to the exhibit. Which two statement s are correct?()

A. All the routes were redistributed into BGP from an IGP
B. All the routes were originated by BGP with the network command
C. All six routes will be installed in the routing table
D. Four routes will be installed in the routing ta ble
E. Two routes will be installed in the routing table


您可能感興趣的試卷

你可能感興趣的試題

1.多項選擇題

Refer to the exhibit. Which two statements are true about the partial configuration that is provided.()

A. The peer group shortens the EBGP configuration
B. The peer group shortens the IBGP configuration
C. All the configured neighbors are in autonomous system 100
D. Three AS - path filters are applied to each BGP neighbor
E. Only the outgoing filters are applied to BGP updates

2.單項選擇題Which of the following is an OSPF configuration parameter that is used on an ABR, but not on an internal router?()

A. A virtual link to area 0.
B. OSPF summarization command.
C. default - cost extension to the area command.
D. no - summary extension to the area stub comm and.
E. None of the other alternatives apply

3.多項選擇題An etwork administrator has enabled OSPF across an NBMA network and has issued the command ip ospf network nonbroadcast. Given those facts, which two statements are true?()

A. Interfaces will automatically detect and build adjacencies with neighbor routers
B. DR and BDR elections will not occur
C. DR and BDR elections will occur
D. The neighbor command is required to build adjacencies
E. All routers must be configured in a fully meshed topology with all other routers

4.單項選擇題According to RFC 2328, what is the stateful order in which an OSPF router transitions to a full adjacency with a neighbor router?()

A. Down, Init, 2 - Way, Exstart, Exchange, Loading, and Full
B. Down, Init, 2 - Wa y, Exchange, Exstart, Loading, and Full
C. Down, 2 - Way, Init, Loading, Exstart, Exchange, and Full
D. Down, 2 - Way, Init, Exchange, Exstart, Loading, and Full
E. Down, Init, 2 - Way, Loading, Exstart, Exchange, and Full
F. Down, 2 - Way, Init, Exstart, Exch ange, Loading, and Full

5.單項選擇題

Refer to the exhibit. OSPF has been configured on all routers in the network and Area 1 has been configured as a NSSA. Which statement is true about the NSSA Area 1?()

A. Only redistributed RIP routes will appear in Area 1. They will be advertised via t ype 7 LSAs
B. No redistributed routes can appear in Area 1, only summary routes
C. Redistributed RIP and IGRP routes will appear in Area 1. They will be advertised via type 5 LSAs
D. Only redistributed IGRP routes will appear in Area 1. They will be advertised via type 7 LSAs

最新試題

The following configura tion exists on a router on one end of an IPv6 tunnel. Which type of tunnel is created by this configuration?()interface loopback 1ip address 1.1.1.1 255.255.255.255interface tunnel 2ipv6 address 2000::1::/64tunnel source loopback 1tunnel destina tion 2.2.2.2tunnel mode ipv6ipipv6 eigrp 1

題型:?jiǎn)雾?xiàng)選擇題

Which of the following must match for  two directly connected routers running OSPF to establish a neighbor adjacency?()

題型:多項選擇題

Router R1 currently has no configuration related to IPv6 or IPv4. The following configuration exists in a planning document, intended to be used to copy/paste into Router R1 to enable OSPFv3 on interfaces F0/0 and S0/0/0. No other related configuration exists. Assuming F0/0 and S0/0/0 reach an up/up state, which of the following is true about OSPFv3 on R1 after this configuration has been pasted into R1?()ipv6 router ospf 1ipv6 unicast- routinginterface f0/0ipv6 address 2000 ::1/64ipv6 ospf 1 area 1interface s0/0/0ipv6 address 2001::/64 eui - 64ipv6 ospf 1 area 0

題型:?jiǎn)雾?xiàng)選擇題

An ISP has assigned prefix 3000:1234:5678::/48 to Company1. Which of the following terms would typically be used to describe this type of public IPv6 prefix?()

題型:?jiǎn)雾?xiàng)選擇題

Look at the following configuration below and select the statements that are true.()RD2(config)#router ospf 100RD2(config - router)# distance 180 10.1.10.1 0.0.0.0 match - meRD2(config -router)#!RD2(config - router) #ip access - list standard match - meRD2(config - std - nacl)# permit host 172.16.0.0

題型:多項選擇題

An engineer is reviewing another engineer's sample configuration for a GRE tunnel used to pass IPv6 traffiC. The tunnel ha s not yet been configured on the router.Which of the following commands is not required for the configuration to pass IPv6 traffic?()

題型:?jiǎn)雾?xiàng)選擇題

Router R1, a branch router, connects to the Internet using DSL. Some traffic flows through a GRE and IPsec tunnel, over the DSL connection, and into the core of an Enterprise network. The branch also allows local hosts to communicate directly with public sites in th e Internet over this same DSL connection.Which of the following answers defines how the branch NAT config avoids performing NAT for the Enterprise directed traffic but does perform NAT for the Internet - directed traffic?()

題型:?jiǎn)雾?xiàng)選擇題

Router R1 connects to Router R2 over an Ethernet LAN with both routers using their F0/0 interfaces. R1 learns a route from R2 using EIGRP f or IPv6. That route lists F0/0 as the outgoing interface with R2 as the next hop. The configuration excerpt shows all relevant configuration on R2's F0/0 interface. Which of the following is true about R1's route?()interface f0/0mac - address 1111.1111.1 111ipv6 address 2000::/64 eui - 64ipv6 address 2001::1/64

題型:?jiǎn)雾?xiàng)選擇題

The following line of output was gathered on Enterprise Router Ent1 using the command show ip route. Which of the following answers is most likely to be true, based on thi s output?()B 128.107.0.0 [20/10] via 11.11.11.11, 00:02:18

題型:?jiǎn)雾?xiàng)選擇題

A client host uses IPv4 to communicate with one ser ver and IPv6 to communicate with another.Which of the following IPv6 coexistence features is likely at work on the host?()

題型:?jiǎn)雾?xiàng)選擇題