A.The use of a queuing method that will give VoIP traffic strict priority over other traffic
B.The use of RTP header compression for the VoIP traffic.
C.The proper classification and marking of the traffic as close to the source as possible
D.The use of 802.1QinQ trunking for VoIP traffic
E.The use of WRED for the VoIP traffic
您可能感興趣的試卷
你可能感興趣的試題
You need to troubleshoot some problems in the Company VOIP network associated with jitter.
What is the cause of jitter？ （）
A. Packet drops
B. Transmitting too many small packets
C. Variable queue delays
D. Compression
E. None of the other alternatives apply
The Lightweight Access Point Protocol （LWAPP） is in use within the Company wireless network.
Which two statements correctly describe features of this protocol？ （）
A. Control traffic between an access point and a controller is encrypted within LWAPP.
B. Data traffic between an access point and a controller is encrypted within LWAPP.
C. Layer 3 mode packets are transmitted in TCP frames.
D. Data traffic between an access point and a controller is encapsulated within LWAPP.
E. VLAN tagging and QoS markings are applied at the access point.
Which statement about the Lightweight Access Point Protocol （LWAPP） is true？ （）
A. LWAPP encrypts both control traffic and user data.
B. LWAPP encrypts user traffic with an x.509 certificate using AES-CCMP.
C. When set to Layer 3， LWAPP uses a proprietary protocol to communicate with the Cisco Aironet APs.
D. LWAPP encrypts control traffic between the AP and the controller.
E. None of the other alternatives apply.
Which set of statements describes the correct order and process of a Company wireless user client associating with a wireless access point in the Company network？ （）
A. 1. Access point sends probe request .2. Client sends probe response.3. Client initiates association.4. Access point accepts association.5. Client adds access point MAC address to association table.
B. 1. Client sends probe request.2. Access point sends probe response.3. Client initiates association.4. Access point accepts association.5. Access point adds client MAC address to association table.
C. 1. Client sends probe request.2. Access point sends probe response.3. Access point initiates association.4. Client accepts association.5. Access point adds client MAC address to association table.
D. 1. Access point sends probe request .2. Client sends probe response.3. Client initiates association.4. Access point accepts association.5. Access point adds client MAC address to association table.
E. 1. Client sends probe request.2. Access point sends probe response.3. Client initiates association.4. Access point accepts association.5. Client adds access point MAC address to association table.
F. None of the other alternatives apply.
Which statement is true about the data traffic between the access point named TKAP1 and controller TKC1？（）
A. The data traffic between the access point and controller is not encrypted.
B. The data traffic is encapsulated with LWAPP.
C. The data traffic is switched at the access point before being sent to the WLAN controller where VLAN tagging and QoS are applied.
D. The data traffic is encrypted with AES.
E. All of the above
最新試題
Refer to the exhibit. What will happen when one more user is connected to interface FastEthernet 5/1？ （）
Refer to the exhibit. For what purpose is the command show ip cef used？（）
Which statement is correct about the use of the virtual interface on a WLC ？（）
Refer to the exhibit. LACP has been configured on Switch1 as shown. Which is the correct command set to configure LACP on Switch2？（）
Refer to the exhibit and the partial configuration of switch SW_A and SW_B. STP is configured on all switches in the network. SW_B receives this error message on the console port：00：06：34： %CDP-4-DUPLEX_MISMATCH： duplex mismatch discovered on FastEthernet0/5 （not half duplex）， with SW_A FastEthernet0/4 （half duplex） ， with TBA05071417（Cat6K-B） 0/4 （half duplex）. What would be the possible outcome of the problem？（）
If G1/0/1 on DS1 is shutdown， what will be the current priority value of the Vlan105’s group on DS1 ？（）
Refer to the exhibit. Based on the output of the show spanning-tree command， which statement is true？ （）
What is the configured priority value of the Vlan105’s group on DS2 ？（）
Refer to the exhibit. All network links are FastEthernet. Although there is complete connectivity throughout the network， Front Line users have been complaining that they experience slower network performance when accessing the server farm than the Reception office experiences. Based on the exhibit， which two statements are true？（）
Which three statements about STP timers are true？（）