A. source MAC address
B. source IP address
C. source switch port
D. destination IP address
E. destination port address
F. destination MAC address
您可能感興趣的試卷
你可能感興趣的試題
A. The frame is dropped.
B. The frame is addressed with a broadcast MAC address and sent out all ports.
C. The frame is sent out all ports except the receiving port.
D. An ARP request is sent out all ports except the receiving port.
E. A destination unreachable message is sent back to the source address.
F. None of the above.
A. A device waits for an electronic signal before transmitting.
B. A device listens and waits until the media is not busy before transmitting.
C. All devices on an Ethernet segment see data that passes on the network medium.
D. Only the sender and the receiver devices see data that passes on the network medium.
E. Ethernet networks allow you to configured devises with higher transmission priority.
A. Hosts use a logical ring topology.
B. Hosts use a logical bus topology
C. Hosts must wait for an electronic signal to transfer data.
D. Hosts are directly connected to a wiring concentrator called a MSAU.
A. Each device on the Ethernet segment stops transmitting for a short time.
B. A jam signal informs all devices that a collision occurred.
C. When data transmission resumes, the devices that were involved in the collision have priority to transmit.
D. The devices that are involved in the collision stops transmitting for a short time.
E. The collision invokes a random back-off algorithm.
A.172.31.128.255./18
B.255.255.255.255
C.192.168.24.59/30
D.224.0.0.5
E.All of the above
最新試題
The network 172.12.0.0 needs to be divided into subnets where each subnet has the capacity of 458 IP addresses.What would be the correct subnet mask to accomplish this division keeping the number of subnets at the maximum? （）
What is a global command?（）
Which connections allow the use of full-duplex Ethernet?（）
What should the configuration register value be after successfully completing the password recover procedure and returning the router to normal operation? （）
What does a configuration Register Setting of 0x2105 indicate to the Router? （）
What is the purpose of pressing the Ctrl+Break keys during the router password recover procedure?（）
Five minutes after issuing the show running-config command, a technician enters the command again and notices that several access list statements have been altered. Because of this, the technician believes that the router is being configured by an unknown person through Telnet. Before changing the router passwords, the technician would like to discover if anyone is connected to the router by Telnet and stop them from making further changes.Which commands will accomplish these options?（）
A router with a serial interface will be used for an ISDN link.What other function group devices are required to complete the connection to the service provider? （）
Which of the following options lists the steps in PPP session establishment in the correct order?（）
How many usable sub network and usable hosts per subnet result in the network address 201.105.13.0 is sub netted with a mask of /26? （）