A. 20
B. 10
C. 0
D. 1
您可能感興趣的試卷
你可能感興趣的試題
Refer to the exhibit. Which statement is true? （）
A. Only traffic with a destination from 10.10.0.0/19 will be permitted.
B. Router RAR1 will accept only route 10.10.0.0/19 from its BGP neighbor.
C. Only traffic going to 10.10.0.0/19 will be permitted.
D. Router RAR1 will send only route 10.10.0.0/19 to its BGP neighbor.
Refer to the exhibit. What statement is true base d upon the configuration in the exhibit? （）
A. CGMP version 2 is being used.
B. The switch will use sparse mode first, dense mode second.
C. A rendezvous point must be configured in order for the interface to operate in sparse mode.
D. IGMP version 2 is being used.
E. The rendezvous point is IP address 172.16.4.16.
F. If a rendezvous point is configured, the interface cannot operate in dense mode.
Refer to the exhibit. Which two conclusions can be drawn from the debug ip igmp output?（）
A. The router sent an IGMP version 2 query out interface Ethernet1 at multicast address 224.0.0.1.
B. Router RTA received an IGMP report version 1 from host 192.168.9.1.
C. Reverse Path Forwarding (RPF) is ena bled for 192.168.9.4.
D. Reverse Path Forwarding (RPF) is enabled for 224.0.1.40.
E. The IP multicast groups are 224.0.0.1, 224.0.1.40, and 239.255.0.1.
F. IP PIM RP mapping is static.
A. IGMP
B. IGMP snooping
C. PIM
D. CGMP
E. static assignment
F. CDP
A. Sparse mode multicast uses a pull model to send multicast traffic to where it is requested
B. Dense mode multicast uses a push model to flood traffic throughout the network and then prunes the unwanted traffic
C. Dense mode multicast requires explicit join messa ges from their members
D. Sparse mode uses reverse path forwarding (RPF) to prune off redundant flows
E. The primary use of sparse mode multicast is for test labs and router performance testing
最新試題
An engineer is trying to summarize the following networks using the "ip summary- address eigrp"command:10.8.88.0/2510.8.89.48/2910.8.64.96/27Which network and subnet mask below would be the smallest EIGRP summary address to include all three subnets?（）
Router R1, a branch router, connects to the Internet using DSL. Some traffic flows through a GRE and IPsec tunnel, over the DSL connection, destined for an Enterprise network.Which of the following answers best describes the router's logic that tells the router, for a given packet, to apply GRE encapsulation to the packet?（）
Router R1 has the following configuration. Assuming R1's F0/0 interface has a MAC address of 0200.0011.1111, what IPv6 addresses will R1 list for interface F0/0 in the output of the show ipv6 interface brief command?（）interface f0/0ipv6 address 2345:0:0:8::1/64
The following line of output was gathered on Enterprise Router Ent1 using the command show ip route. Which of the following answers is most likely to be true, based on thi s output？（）B 128.107.0.0 [20/10] via 11.11.11.11, 00:02:18
Router R1 has been conf igured with an ipv6 route 2000::/64 S0/0/0 64 command.Which of the following does the 64 at the end of the command represent?（）
Which of the following features work the same in both RIP- 2 and RIPng?（）
The following output occurs on Router R1 , which runs both EIGRP for IPv6 and OSPFv3, with redistribution from EIGRP into OSPF configured with the redistribute eigrp 1 metric 25 command. Interface S0/0/1 has been enabled for EIGRP ASN 1. Which of the following should be true of redistribution in this case?（）D 2000::/64 [90/1422516]via FE80::213:19FF:FE7B:5026, Serial0/0/1C 2000:0:0:1::/64 [0/0]via Serial0/0/1, directly connectedL 2000::1:213:19FF:FE7B:5004/128 [0/0]via Serial0/0/1, receive
Router R1 currently has no configuration related to IPv6 or IPv4. The following configuration exists in a planning document, intended to be used to copy/paste into Router R1 to enable OSPFv3 on interfaces F0/0 and S0/0/0. No other related configuration exists. Assuming F0/0 and S0/0/0 reach an up/up state, which of the following is true about OSPFv3 on R1 after this configuration has been pasted into R1?（）ipv6 router ospf 1ipv6 unicast- routinginterface f0/0ipv6 address 2000 ::1/64ipv6 ospf 1 area 1interface s0/0/0ipv6 address 2001::/64 eui - 64ipv6 ospf 1 area 0
Router R1 currently has no configuration related to IPv6 or IPv4. The following configuration exists in a planning document, intended to be used to copy/paste into Router R1 to enable RIPng and IPv6 on interfaces F0/0 and S0/0/0. No other related configuration exists. Which of the following is true about RIPng on R1 after this configuration has been pasted into R1?（）ipv6 unicast- routinginterface f0/0ipv6 rip one enableipv6 address 2000::1/64interface s0/0/0ipv6 address 2001::/64 eui - 64ipv6 rip one enable
Router R1 sits at an Enterprise branch office, using the Internet for its only connectivity back to the rest of the EnterprisE.Which of the following is not a ben efit of using an IPsec tunnel for packets sent through the Internet, between R1 and the rest of the Enterprise?（）