A. forms adjacencies with all neighbors
B. supports demand circuit routing
C. provides routing support for multiple network layer protocols
D. utilizes SPF algorithm
E. provides for network scalability by allowing the network to be separated into areas
F. three layers of hierarchical routing
您可能感興趣的試卷
你可能感興趣的試題
A. Internet Protocol address
B. Media Access Control address
C. Packet Layer Proto col address
D. Network Service Access Point address
E. Authority and Format Identifier address
A. The cost is set to 10 for all interfaces.
B. The cost is set to 10 for LAN interfaces and 20 for WAN interfaces.
C. The cost is based on the speed of the interface.
D. The cost is based o n a composite of bandwidth and delay of the interface.
A. complete SNP (CSNP)
B. partial SNP (PSNP)
C. hello
D. database query
E. database description packet (DDP)
A. complete SNP (CSNP)
B. partial SNP (PSNP)
C. database query
D. database description packet (DDP)
E. link - state summary
F. hello
A. Configure the net system - id command under routerisis and enable IS - IS on each interface with the ip router isis command.
B. Configure the net sy stem - id and the network net - id commands under routerisis.
C. Configure the network net - id command(s) under routerisis and enable IS - IS on each interface with the ip router isis command.
D. Configure the network net - id command(s) and the is - type level -1- 2 command under routerisis.
E. Configure the net system - id and the network net - id commands under routerisis and enable ISIS on each interface with the ip router isis command.
最新試題
Router R1 has two LAN interfaces and three serial interfaces enabled for IPv6. All the inte rfaces use link local addresses automatically generated by the router.Which of the following could be the link local address of R1's interface S0/0?（）
An engineer is reviewing another engineer's sample configuration for a GRE tunnel used to pass IPv6 traffiC. The tunnel ha s not yet been configured on the router.Which of the following commands is not required for the configuration to pass IPv6 traffic?（）
An ISP has assigned prefix 3000:1234:5678::/48 to Company1. Which of the following terms would typically be used to describe this type of public IPv6 prefix?（）
Router R1 lists the following output from a show command. Which of the following is true about R1?（）R1# show ip v6 interface f0/0FastEthernet0/0 is up, line protocol is upIPv6 is enabled, link - local address is FE80::213:19FF:FE12:3456No Virtual link - local address(es):Global unicast address(es):2000::4:213:19FF:FE12:3456, subnet is 2000:0:0:4::/64 [EUI]Jo ined group address(es):FF02::1FF02::2FF02::1:FF:12:3456
Router R1 has been conf igured with an ipv6 route 2000::/64 S0/0/0 64 command.Which of the following does the 64 at the end of the command represent?（）
The following configuration exists on a router on one end of an IPv6 tunnel. Although the configuration added so far is correct, the configuration is incomplete. Which type of tunnel is most likely to be intended by the network engineer？（）interface loopback 1ip address 192.168.1.1 255.255.255.255interface tunnel 2ipv6 address 2002:C0A8:10 1::1/64tunnel source loopback 1
Router R1 sits at an Enterprise branch office, using the Internet for its only connectivity back to the rest of the EnterprisE.Which of the following is not a ben efit of using an IPsec tunnel for packets sent through the Internet, between R1 and the rest of the Enterprise?（）
Which of the following are true of both OSPFv2 and OSPFv3?（）
Which of the following is the shortest valid abbreviation for FE80:0000:0000:0000:0010:0000:0000:0123?（）
The following output occurs on Router R1 , which runs both EIGRP for IPv6 and OSPFv3, with redistribution from EIGRP into OSPF configured with the redistribute eigrp 1 metric 25 command. Interface S0/0/1 has been enabled for EIGRP ASN 1. Which of the following should be true of redistribution in this case?（）D 2000::/64 [90/1422516]via FE80::213:19FF:FE7B:5026, Serial0/0/1C 2000:0:0:1::/64 [0/0]via Serial0/0/1, directly connectedL 2000::1:213:19FF:FE7B:5004/128 [0/0]via Serial0/0/1, receive