A.Transmit only
B.Diversity
C.Receive only
D.Single isolated antenna
您可能感興趣的試卷
你可能感興趣的試題
A.LOS modulation
B.Multipath distortion
C.RF signal absorption
D.RF signal attenuation
E.Fresnel zone impedance
A.Add a new 802.11a WLAN
B.Increase the Layer 2 and Layer 3 security of the WLAN
C.Increase the throughput for the wireless clients
D.Add new services （such as voice） over the WLAN
A.Identify potential problem areas
B.Define intended coverage areas
C.Access compliance with local building codes
D.Determine the final location of APs and antennas
E.Identify sources of RF signal attenuation and RF interference
A.Implementation suggestions
B.Access point locations
C.Security requirements
D.Access point mounting methods
A.Access point received-signal strength level
B.Spectrum utilization
C.Client data rate
D.In-band radio frequency interference
最新試題
How should the transmit power on an access point and client each be set during a site survey？（）
Which statement regarding the site-survey process is correct？（）
Which can NOT be selected for supported services in Cisco WCS Planning Tool？（）
Which two Cisco antennas provide better isolation from RF sources that might be located behindthe antennas？（）
Which three formats can be used to import floor maps in Cisco WCS v5.2？（）
What will cause wireless voice devices to perform poorly？（）
What is a site survey best practice for location-based services？（）
A design requires 100 access points with high channel bandwidth and disabled lower data rates.How are the data rates set on the Cisco WLC and Cisco WCS？（）
When using a lightning arrestor， connect which type of ground wire to a good earth ground？（）
After the site installation is complete， you should verify the mobility of the VoWLAN device whilewalking the site on an active phone call. Which Cisco WLC or Cisco WCS command is mostbeneficial in determining roaming efficiency？（）