HSRP. Known as Hot Stanclby Router Protocol, is a Cisco proprietarv redundancy protocol . As an experienced network administrator, you are required to configure HSRP on a XYZ network.
Which TWO of the following wii be available and shared between the routers configured with HSRP? （）(Choose two.)
A. a shared single interface
B. the ability to track serial interfaces
C. UDP-based hello packets
D. the impact of flapping links if timers are too low
您可能感興趣的試卷
你可能感興趣的試題
A. It is achieved by using more than one HSRP group.
B. It is done in regards to either round robin or weight basis.
C. It is used to offload the active router in a certain HSRP group.
D. The return traffic is influenced by HSRP load sharing configuration.
E. Single group HSRP is used to achieve more efficient link utilization.
A.0000.5E00.010a
B.0000.0c07.ac0a
C.0000.0c07.0110
D.000.0cac.070a
A. Proxy ARP
B. IRDP
C. Dynamic Routing Protocol
D. VRRP
A.Both Gateway Load Balancing Protocoland Hot Stand by Router Protocol
B.Gateway Load Balancing Protocol
C.Virtual Router Redundancy Protocol
D.Hot Stand by Router Protocol
A. Shared single interface
B. IP Address
C. TCP-based hello packets
D. MAC address
最新試題
Which configuration will enable OSPF for IPv6 on FastEthernet 0/0/0?（）
Which Cisco IOS command is used to troubleshoot a problem in which a BGP session stays in the active state?（）
What are four advantages to using tunnel brokers in an IPv6 transition environment?（）
Which command displays only those entries in a BGP table with specific AS_PATH attributes?（）
You are an experienced network administrator in an international corporation. During your working hours, you are asked to deploy the Cisco SSL VPN AIM module in a Cisco 1800 Series Router. The beneficial reason for that deployment is to:（）
Refer to the exhibit. You want to minimize the downtime that results from supervisor engine switchovers on Cisco 6500 Series Switches and Cisco 7600 Series Routers. To achieve this, you are considering deploying a Cisco Nonstop Forwarding with Stateful Switchover solution using OSPF.In the exhibit you can see the output of the show ip ospf neighbor detail command.Which trait of systems using Cisco Nonstop Forwarding with Stateful Switchover and OSPF is shown in the exhibit output and will impact your plan?（）
Refer to the exhibit. Which two of these events will be the result of issuing the above command? （）(Choose two.)
What is the most likely reason that an IBGP route that has been selected as a best route is not entered into the IP routing table?（）
Refer to the exhibit. You want to minimize the downtime that results from supervisor engine switchovers on Cisco 6500 Series Switches and Cisco 7600 Series Routers. To achieve this, you are considering deploying a Cisco Nonstop Forwarding with Stateful Switchover solution using OSPF.In the exhibit you can see the output of the show ip ospf neighbor detail command.Which trait of systems using Cisco Nonstop Forwarding with Stateful Switchover and OSPF is shown in the exhibit output and will impact your plan?（）
Refer to the exhibit. For the given configuration, on packets leaving the router on interface FastEthernet0/0 that matches the high traffic class, what will the MPLS experimental bit be set to?（）