During the installation of the Cisco WCS， an error occurs.
Where will the installation log be found？（）
A.at the root of the installation drive
B.in the Cisco WCS installation directory
C.on the desktop of the server
D.in the Cisco WCS\Logs directory
您可能感興趣的試卷
你可能感興趣的試題
A lightweight access point has been connected to a Catalyst 3550 24-PWR switch， and on power-up the access point fails.
What is the problem with the switch？（）
A.The power supply has inadequate wattage.
B.Power is incorrectly configured on the port.
C.It does not support 802.3af Poe.
D.Power is not enabled on the port.
Two access points running the core feature set are connected to the same switch and are providingguest services.
If PSPF is enabled， what must be enabled on the switch to prevent clients fromseeing one another’s data？（）
A.port-based RADIUS
B.802.1q trunking
C.inline power
D.protected port
A.startup
B.site survey mode
C.lost connection to the controller
D.duplicate IP address
Last December you erected a bridge link between two buildings on your campus. It is now Apriland the foliage in the trees is full， and the bridge link will no longer maintain connectivity.
Which action will most likely solve the problem？（）
A.Change the channel selection.
B.Install higher gain antennas.
C.Raise the antennas.
D.Increase transmitter power.
An 802.1X client cannot authenticate to an autonomous access point configured for multiple
VLANs. The native VLAN does not have an SSID configured.
Which one of the following links being down would prevent the clients from authenticating？（）
A.between the RADIUS and the access point
B.between the client’s VLAN and the WLSE
C.between the native VLAN and the WLSE
D.between the client’s VLAN and the RADIUS
最新試題
Which of the following commands on the wireless interface of a Cisco 3845 Integrated Service Router allows the SSID to broadcast？（）
You are troubleshooting a one-way call problem with a Cisco 7920 wireless IP phone on a standalone WLAN.What may cause this problem？（）
You have been called upon to add location-based services into an existing controller-basedwireless design which primarily encompasses handheld devices such as barcode scanners and Cisco7920 wireless IP phones.In which mode should you deploy the additional access points to achievethe density required without excessive co-channel interference？（）
You are troubleshooting a problem with a Cisco 7920 wireless IP phone on a standalone WLAN.The phone rings but， when you answer， the call is dropped.What may cause this problem？（）
You have a very few Cisco 7920 wireless IP phones on your network， but lots of wireless laptops.You want to increase the bandwidth available for the laptops by decreasing the bandwidth reserved for the Cisco 7920 phones.What is the lowest percentage of voice-allocated bandwidthyou can select on the WLAN controller？（）
Clients using Cisco-LEAP and EAP-FAST authentication are having no problems logging on to thewireless network， but clients using PEAP are failing to log on.Which situation would result in thistype of problem？（）
You review the Failed Attempts logs on an AAA server and find： "unknown network access servererror." Which failure could produce this error？（）
You are charges with implementing a secure wireless installation which will provide Internet accessto client devices but will not allow communications between wireless clients.In addition to implementing PSPF or peer-to-peer blocking on the wireless side，which of the following actionsshould you perform on the wired infrastructure？（）
The IOS of a North American Cisco Aironet 1130AG Series standalone access point has becomecorrupt. You must therefore reload the TFTP firmware.Before you press and hold the MODEbutton， you should verify that the file name is which of the following？（）
Which of the following parameter sets must be configured on the Cisco Wireless Location Appliance？（）