You are installing a Cisco ONS 15454 SDH in a service provider site. An E3 cable is being connected to a digital cross-connect system.
What is the maximum distance allowed between the two？（）
A. 225 ft
B. 450 ft
C. 655 ft
D. 900 ft
您可能感興趣的試卷
你可能感興趣的試題
A. An equal amount of working and protect bandwidth is required.
B. DCC bandwidth is not large enough to handle K1/K2 processing.
C. Switch times would exceed 50 ms for an STM-1 MS-SPRing ring.
D. There is not enough bandwidth in an STM-1 ring to justify MS-SPRing protection.
You are provisioning an E-1 circuit on an ONS 15454 SNCP configuration and XC-VXL-10G card.
How many total ports are used within the Low-Order matrix at the source node？（）
A. 0
B. 1
C. 2
D. 3
E. 5
A. It protects signals against node failures between rings.
B. It protects signals against node failure within a single ring.
C. It allows for traffic to be preempted when a ring switch occurs.
D. Traffic can be dropped and continued at interconnecting nodes.
E. It protects preemptible traffic from being dropped when a ring switch occurs.
A customer would like to create a 1：1 protection group with a DS3Ni-12 card.
Where should it be placed in the chassis？（）
A. only Slots 6 or 12
B. only Slots 3 or 15
C. high or low speed slots
D. directly adjacent to the working card
E. high-speed slots only （5/6 and 12/13）
A customer has 20 E1s to add between far-end nodes in an SNCP ring.
What type of circuit would you recommend？（）
A. LO-PATH circuits
B. HO-PATH circuits
C. 1：1 protection circuits
D. 1：N protection circuits
E. LO-PATH tunnel circuits
最新試題
Which timing mode is appropriate for an SDH NE that is adjacent to an SDH NE Bits-1 timing？ （）
If the dispersion of a given fiber is 17ps/nm*km at 1550 nm and zero at 1310 nm， then what is the accumulated dispersion of an ITU wavelength after it travels 200 km？ （）
Which is a legitimate bandwidth matched pair？（）
What are three factors that limit the maximum distance of an amplified optical signal without regeneration？ （）
Click the Exhibit button. What is the maximum allowable loss budget between the ONS 15216 Mux （left side） composite output and the ONS 15216 Demux （right side） composite input， with the optical values given in the exhibit？ （Assume the worst case loss of 4.5 dB for 15216 200 GHz Mux/Demux and ignore power penalties or extra margin.） （）
A 2.5 Gb/s （OC-48 or STM-16） optical signal with a dispersion tolerance of 1200 ps/nm goes through fiber with 18ps/nm*km of dispersion. How many 15216-DCU-350 equivalents are needed for enough compensation after traveling 100 km？（）
What is the difference between the transmitted power and the sensitivity of the receiver？ （）
What is the phenomenon called where different wavelengths of light travel at different speeds？（）
The dispersion of a non-zero dispersion shifted fiber is 6 ps/nm*km at 1550 nm and 10 ps/nm*km at 1610 nm. What is the minimum dispersion compensation required if an L-Band DWDM signal travels through 200 km of fiber and has a dispersion tolerance of 1800 ps/nm？（）
In the OSNR model for EDFA amplifiers， SNR OUT = 1/（1/SNR IN + FhvB/P IN ）， what does SNR IN represent？（）