CCNA系列認證CCNA(640-801)章節練習(2019.04.25)

來源：考試資料網

1 While troubleshooting a network connectivity issue, you suspect that a router may be missing a route, or may be receiving bad routing information to a destination. What command should you issue to view the route that the router will use to reach a given destination?（）

點擊查看答案

2 Which command is required for connectivity in a Frame Relay network if Inverse ARP is not operational?（）

點擊查看答案

3 The following was issues on router TestKingA:
TestKingA #show ip ospf neighbor
Neigbor ID PRI State Dead Time Address Interface
192.168.1.2 1 Full/- 00:00:37 192.168.1.2 Serial1
Which type of OSPF network will provide the output shown in the graphic?（）

點擊查看答案

4 If the bandwidth of an OSPF interface is configured with the "bandwidth 64"command, what would be the calculated cost of the link?（）

點擊查看答案

5 You are working as an administrator at TestKing, and you need to set the bandwidth of your routers serial port to 56K. Which of the following commands would you use?（）

點擊查看答案

6 At a branch location, TestKing.com has deployed a non modular router that is equipped with two serial interfaces and two Ethernet interfaces.What additional equipment must be used to allow the branch office to connect to the central office by using an ISDN service?（）

點擊查看答案

7 What are some characteristics of the typical VLAN arrangement?（）

點擊查看答案

8 What does a configuration Register Setting of 0x2105 indicate to the Router? （）

點擊查看答案

9 You are bringing up a new Cisco Catalyst switch, and wish to connect it via a trunk to another switch from a different vendor, which uses the IEEE standard for the trunking method.
When setting the encapsulation type on the trunk, what should you configure on the Cisco switch?（）

點擊查看答案

10 When configuring Frame Relay using point-to-point subinterfaces, which of the following must not be configured?（）

點擊查看答案