A.high discharge pressure
B.frosting of the crankcase
C.high temperature of the overboard water
D.low suction pressure of compressor
您可能感興趣的試卷
你可能感興趣的試題
A.upper part of the receiver
B.upper part of the condenser
C.down stream end of the cooling coil
D.outlet end of the condenser
A.icing of the automatic controls
B.embrittlement of some parts of the automatic controls
C.sludge in the lubricating oil
D.all of the above
A.low water level
B.high water level
C.excessively high fuel pressure
D.low oil temperature
A.excessive water in the bilges
B.a clogged suction strainer
C.oil in the bilges
D.All of the above
A.in the store room
B.in the cylinder
C.in the scavenge air box
D.in the water box
最新試題
The general purpose of a heat exchanger is to （）.
Thermostatic expansion valves can be adjusted for （）.
Which of the problems listed would came the discharge temperature of an R-12 refrigeration compressor to increase?（）
Pitting in the suction areas of a centrifugal pump bronze impeller is usually caused by （）.
If you are given the job of adding hydraulic fluid to a mooring winch, and are not certain as to the type of fluid to use, you should （）.
A grease gun is generally used to lubricate a （）.
Which of the following problems could cause the high pressure cutout switch to shut down the compressor in a refrigeration system?（）
If the head pressure of a reciprocating refrigeration compressor is excessive, （）.
A gradual decrease in the discharge pressure of an operating hydraulic pump can be caused by （）.
One cause of high head pressure occurring in a refrigeration system can be （）.