A.insufficient cooling water flow to the condenser
B.a low refrigerant charge in the system
C.the liquid valve is open too much
D.high evaporator superheat
您可能感興趣的試卷
你可能感興趣的試題
A.dead band action
B.neutral zone action
C.range
D.on-off action
A.cavitation
B.electrolysis
C.abrasion
D.corrosion
A.the relief valve should open before the high pressure cutout
B.the relief valve should open and allow the excess refrigerant to flow to the receiver
C.the high pressure cutout switch should operate before the relief valve opens
D.you should close in on the suction valve
A.cause of salt contamination
B.location of salt water contamination
C.chemical makeup of feed-water
D.level of alkalinity in condensate
A.restriction in refrigerant piping
B.air and non-condensable gases in the condenser
C.water in the refrigerant
D.flooding back of liquid refrigerant from the evaporator
最新試題
The rate of heat transfer from a hot region to a cold region is affected most by the （）.
If the relief valve on the discharge side of a hydraulic pump lifts, the cause could be （）.
If the suction pressure at the refrigeration compressor is below normal, the cause can be（）.
An internal bypass is provided on some hydraulic system suction strainers to help reduce the possibility of （）.
A salinity indicator is used to determine the （）.
An increasing head pressure in a refrigeration system, without any corresponding change in the cooling water inlet temperature, would probably be caused by （）.
If the viscosity of the liquid being transferred remains constant as the discharge pressure increases, the rotary pump （）.
The major source of chemical contaminants in hydraulic fluid is （）.
The general purpose of a heat exchanger is to （）.
The amount of fluid friction or internal friction inherent in a mineral lubricating oil is reflected as a measure of its （）.