A.central valve
B.radial plunger
C.floating ring
D.cylinder body
您可能感興趣的試卷
你可能感興趣的試題
A.moisturizing
B.dehumidification
C.dampening
D.humidification
A.compressor is overloaded
B.motor is overloaded
C.foundation bolts are loose
D.belts are too tight
A.rapidly
B.by gravity
C.through a standard orifice at a specified temperature
D.at a rate of 60cc per second
A.flooding back
B.superheating
C.overflowing
D.recycling
A.Absorb erosion of high velocity discharge stream
B.Seal pump shaft against entry of air
C.Isolate the discharge side from the suction side
D.Dampen the turbulent discharge flow
最新試題
Pitting in the suction areas of a centrifugal pump bronze impeller is usually caused by （）.
An excessive charge of refrigerant in an air-cooled refrigeration system can cause （）.
The control mode in which the final control element is moved from one of two flexed positions to the other is known as （）.
One cause of high head pressure occurring in a refrigeration system can be （）.
If the viscosity of the liquid being transferred remains constant as the discharge pressure increases, the rotary pump （）.
If the relief valve on the discharge side of a hydraulic pump lifts, the cause could be （）.
The rate of heat transfer between the hot and cold fluids passing through a shell-and-tube type heat exchanger will （）.
If the suction pressure at the refrigeration compressor is below normal, the cause can be（）.
Which of the following problems could cause the high pressure cutout switch to shut down the compressor in a refrigeration system?（）
If you are given the job of adding hydraulic fluid to a mooring winch, and are not certain as to the type of fluid to use, you should （）.