A.acid formation
B.sludge formation
C.ice in the expansion valve
D.All of the above
您可能感興趣的試卷
你可能感興趣的試題
A.superheated outside the system
B.in contact with an open flame
C.heated to the boiling point
D.All of the above
A.Variable volumes can be obtained with gear pumps only by variation of the pump drive speed
B.A radial piston pump houses sliding pistons in a stationary cylinder block through which passes a rotating pintle or ported shaft
C.The amount of fluid displaced per revolution of an axial piston rotary pump is dependent on the angle formed between the cylinder block and valve plate
D.All of the above
A.transmit the rudder angle to the bridge indicator
B.prevent the control linkage from striking the stops when hard over
C.automatically purge all entrained air from the system
D.send hydraulic signals to the receiving unit
A.horizontally mounted
B.never fitted with intake filters
C.fitted with intercoolers
D.operated in an unloaded condition at all times
A.High pressure compressors are more efficient than low pressure compressors
B.Mechanical efficiency divided by compressor efficiency will equal the overall efficiency of the compressor unit
C.Two stage compressors are generally more efficient than single stage compressors
D.The volumetric efficiency is decreased in multistage compressors
最新試題
If you are given the job of adding hydraulic fluid to a mooring winch, and are not certain as to the type of fluid to use, you should （）.
The rate of heat transfer from a hot region to a cold region is affected most by the （）.
The usual symptoms of cavitation in a centrifugal pump is （）.
On tank vessels equipped with power operated cargo tank valves, the type of power operator most commonly used is （）.
The amount of fluid friction or internal friction inherent in a mineral lubricating oil is reflected as a measure of its （）.
Which of the problems listed would came the discharge temperature of an R-12 refrigeration compressor to increase?（）
The major source of chemical contaminants in hydraulic fluid is （）.
The rate of heat transfer between the hot and cold fluids passing through a shell-and-tube type heat exchanger will （）.
If the viscosity of the liquid being transferred remains constant as the discharge pressure increases, the rotary pump （）.
If the head pressure of a reciprocating refrigeration compressor is excessive, （）.