A.size of the heat sink
B.temperature difference between the regions
C.size of the heat source
D.total heat of the system
您可能感興趣的試卷
你可能感興趣的試題
A.the four-way control valve failing to shift
B.the bleeder valve sticking in the open position
C.cold hydraulic fluid
D.a clogged air vent falter on the oil reservoir
A.add fluid that is the same color as the fluid in the reservoir
B.add turbine oil because it is always a good substitute
C.add any oil that has the same viscosity as the hydraulic fluid
D.check the winch manufacturers instruction book
A.changing the angle of the tilting plate
B.changing the speed of the pump
C.moving the slide block and rotor
D.moving the shaft trunnion block
A.oil foaming in the compressor
B.higher than normal suction and discharge pressures with a higher box temperature
C.higher than normal discharge pressure with a normal box temperature
D.the compressor to run continuously
A.check hydraulic oil levels every hour
B.check the rams for overheating
C.check for excessive oil leakage from rams
D.drain water from telemotor cylinders each watch
最新試題
The rate of heat transfer between the hot and cold fluids passing through a shell-and-tube type heat exchanger will （）.
The rate of heat transfer from a hot region to a cold region is affected most by the （）.
The major source of chemical contaminants in hydraulic fluid is （）.
The control mode in which the final control element is moved from one of two flexed positions to the other is known as （）.
If the head pressure of a reciprocating refrigeration compressor is excessive, （）.
Which of the problems listed would came the discharge temperature of an R-12 refrigeration compressor to increase?（）
Which of the following statements is correct concerning heat transfer?（）
A salinity indicator is used to determine the （）.
Which of the following problems could cause the high pressure cutout switch to shut down the compressor in a refrigeration system?（）
If the suction pressure at the refrigeration compressor is below normal, the cause can be（）.