A.the system is fully charged
B.there is air leaking in from the condenser
C.ice crystals are forming in the refrigerant
D.the system contains less than a full charge of refrigerant
您可能感興趣的試卷
你可能感興趣的試題
A.Simplex
B.Duplex
C.Canister
D.Bypass
A.condition of the expansion valve
B.moisture in the system
C.condition of the compressor suction valves
D.condenser temperature
A.trick wheel
B.accumulator
C.standby pump
D.telemotor
A.Open the bilge pump for inspection
B.Remove each of the manifold valves
C.Remove only the manifold valve to the affected bilge-well
D.Attempt to pump out another bilge well to determine if the entire system is affected
A.too much refrigerant in the system
B.oil entrained in the refrigerant
C.less than a full charge of refrigerant in the system
D.ice crystals forming in the refrigerant
最新試題
If you are given the job of adding hydraulic fluid to a mooring winch, and are not certain as to the type of fluid to use, you should ().
Which of the problems listed would came the discharge temperature of an R-12 refrigeration compressor to increase?()
The control mode in which the final control element is moved from one of two flexed positions to the other is known as ().
The rate of heat transfer between the hot and cold fluids passing through a shell-and-tube type heat exchanger will ().
If the suction pressure at the refrigeration compressor is below normal, the cause can be().
If the head pressure of a reciprocating refrigeration compressor is excessive, ().
If the thermal bulb of an expansion valve is incorrectly placed at the center of the coil instead of the end, it will ().
When a refrigeration compressor has developed a high head pressure as a result of a refrigerant overcharge, you should ().
The rate of heat transfer from a hot region to a cold region is affected most by the ().
Which of the following statements is correct concerning heat transfer?()