A.system is low on refrigerant
B.high pressure cutout switch is improperly adjusted
C.discharge valves are leaking slightly
D.discharge valves are leaking excessively
您可能感興趣的試卷
你可能感興趣的試題
A.leaky discharge valves on the LP cylinder
B.leaky discharge valves on the HP cylinder
C.insufficient intercooler cooling
D.low ambient air pressure
A.one size larger than the pump discharge nozzle
B.the same size as the pump discharge nozzle
C.one size smaller than the pump discharge nozzle
D.installed with a short radius elbow at the pump
A.purge the condenser if the waterside is dirty
B.check for proper water flow through the condenser
C.increase the high pressure cutout setting
D.reduce the cooling water flow
A.Red
B.White
C.Blue
D.Yellow
A.the flashing of the feed water
B.the condensation of the saltwater feed
C.air ejectors, eductors, or a separate vacuum pump
D.condensation of the distillate
最新試題
The rate of heat transfer from a hot region to a cold region is affected most by the （）.
Which of the problems listed would came the discharge temperature of an R-12 refrigeration compressor to increase?（）
An increasing head pressure in a refrigeration system, without any corresponding change in the cooling water inlet temperature, would probably be caused by （）.
A pressure drop through the refrigerant liquid line may cause （）.
A salinity indicator is used to determine the （）.
The control mode in which the final control element is moved from one of two flexed positions to the other is known as （）.
The output volume of a positive fixed displacement pump can be changed only by （）.
If the thermal bulb of an expansion valve is incorrectly placed at the center of the coil instead of the end, it will （）.
Heavy wear in a particular area of the inner circumference of a packing ring may be caused by （）.
When the steering gear is in operation, you should （）.