A.rudder will respond sluggishly
B.hydraulic rams will over-speed
C.sight glass will show bubbles
D.ram relief valves will lift
您可能感興趣的試卷
你可能感興趣的試題
A.continuous running of the compressor
B.high suction pressure
C.high discharge pressure
D.short cycling of the compressor on the water failure switch
A.the cooling effect of the condensate reduces the compressors efficiency
B.a danger of explosion exists whenever water is present in a compressor
C.water causes erratic operation of pneumatic components
D.the volumetric capacity of the first stage is reduced if water remains
A.the compressor short cycling on high pressure cut out switch
B.high suction pressure
C.high head pressure
D.bubbles in the sight glass
A.The two objects must be in physical contact
B.The two objects must be the same size
C.There must be an existing temperature differential
D.There must be an existing weight differential
A.insufficient lubrication
B.insufficient refrigerant
C.excess refrigerant
D.excessive opening of the expansion valve
最新試題
Which of the problems listed would came the discharge temperature of an R-12 refrigeration compressor to increase?（）
If the relief valve on the discharge side of a hydraulic pump lifts, the cause could be （）.
The rate of heat transfer from a hot region to a cold region is affected most by the （）.
If the head pressure of a reciprocating refrigeration compressor is excessive, （）.
Which of the following statements is correct concerning heat transfer?（）
Pitting in the suction areas of a centrifugal pump bronze impeller is usually caused by （）.
When the steering gear is in operation, you should （）.
An increasing head pressure in a refrigeration system, without any corresponding change in the cooling water inlet temperature, would probably be caused by （）.
The major source of chemical contaminants in hydraulic fluid is （）.
The control mode in which the final control element is moved from one of two flexed positions to the other is known as （）.